Grundig 46 VLE 8160 WL Receiving digital channels, Important notes on environmental protection

Page 7

General information---------------------------------------------------------------------------------

Receiving digital channels

7You require a satellite antenna to receive

digital­ satellite channels (DVB-S).

Your TV supports SCR system (Satellite Chan- nel Router). If your antenna installation is equipped with an Single Cable Distribution multiswitch, all television sets which are con- nected on this antenna can receive the televi- sion channels stand-alone.

7You require a digital roof antenna or indoor antenna (passive or active indoor antenna with its own power supply) to receive digital television channels (DVB-T).

7If you wish to receive digital television chan- nels via your cable system (DVB-C), the an- tenna cable for your cable operator must be connected to the television set.

7Unlike analogue broadcasting, not every channel has its own transmission frequency. Instead, several channels are grouped into what are known as bouquets on a regional or national level. You can find the current trans- mission information on teletext from various broadcasters, or by consulting a current TV guide or the Internet.

7Various digital television channels from private broadcasters are encrypted (DVB-S, DVB-T and DVB-C). Watching these channels and the recording and playback functions are only possible with the appropriate CI module and a SmartCard. Ask your specialist dealer.

The range of channels available from the pub- lic broadcasting institutions (ARD with EinsEx- tra, EinsFestival or ZDF with ZDF Info and all third party broadcasters) are not encrypted and can be received without a SmartCard.

Important notes on environmental protection

7The following information will help you to save resources – and money as well.

7If you are not using your television set for

several­ days, you should pull out the mains plug for environmental and safety reasons. This way the television does not consume any electricity.

7As switching off the television set does not completely disconnect it from the mains, pull out the plug to disconnect it from the mains completely.

7If the device is equipped with a power switch, switching it off using this switch will be suffi- cient. The energy consumed by the television set is reduced to virtually 0 W.

7In standby mode, the television set uses very little energy. However, it may be necessary to leave the television set in standby mode for certain functions (for example automatic switch-on and switch-off and for timer func- tions).

7The television set uses less energy when the brightness is reduced.

Notes on still images

Watching the same image for a long time on the screen may cause a still image remains feebly on the background. Feeble image(s) on the back- ground is originated from LCD/LED technology and does not require any action under guaran- tee. To avoid such cases and/or minimize the impact, you may observe the tips below.

7Do not allow the same TV channel to stay on the screen for a very long time. Channel logos may cause this situation.

7Do not allow the images, which are not full screen, to constantly stay on the screen; if not streamed in full screen format by the broad- caster, you can convert the images to full screen by changing picture formats.

7Higher brightness and/or contrast values will lead this impact to appear faster; therefore, you are recommended to watch your TV in the lowest brightness and contrast levels.

ENGLISH ­7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents LCD TV ­2 English English ­3 Special settingsLNB settings Settings for motorised antennas DiSEqC Operation with a Common Interface ­4 English Device­English ­5 General information Special features of your ­television set­6 English Important notes on environmental protection Receiving digital channelsEnglish ­7 Antenna­ socket »SATELLITE« on the televi- sion set And/or Connecting the antenna and power cordPlug the power cord into a wall socket Connection and preparationEnvironmental note Inserting batteries into the ­remote controlOpen the battery compartment by removing the lid Compartment­ Close the battery compartment. Note­10 English Connections on the television setVideo Controls on the television setEnglish ­11 Navigation in the menus Remote control Main functions­12 English  red Selects pages in teletext Remote control ­ All functionsEnglish ­13 Help Initial set-up and tuning ­television channelsSelecting language, country and operating mode Various settingsEnglish ­15 Tuning the television channels from satellite DVB-SEasy installation Advanced installation­16 English Tuning television channels from the cable provider DVB-C Tuning terrestrial television channels DVB-TEnglish ­17 Selecting channel lists Changing the program table for the digital channels­18 English Skipping channels Deleting channelsChange the order of the channels in the program table Sorting channels in the program tableEnter own names for the favourites lists max characters Sorting channels in the favourite list­20 English As from DVB-T receivers or DVD players­ Picture settingsEnglish ­21 Sound settings Equalizer Exiting the settingSoundeffects SRS TruSurround HDBasic functions Audio language Eco modeAudio settings Zoom functionQuit the electronic TV guide with »MENU« Switch back to the channel selection with »«Zapping function Electronic TV guideChanging the picture format Preparing the 3D function Important information about the 3D function­28 English Watching 3D films 3D SettingsEnglish ­29 ­30 English Adjusting 2D → 3D effectsLeft Right Correction Formats supported by HdmiNetwork connection What is Smart Inter@ctive TVWired network Wired network connection­32 English Wired network settingsAutomatic wired network ­ connection Manual wired network connection»DNS« options are active Manual connectionEnglish ­33 ­34 English Wireless network connectionAutomatic connection Wireless network settingsEnglish ­35 ­36 English English ­37 Smart Inter@ctive TV internet applicationsSelecting internet applications Open the menu »SMART inter@ctive TV« with »@«Press »GUIDE« to end the application Smart İnter@ctive browser main menuNavigation in the main menu Playing and other options in the applications»dlna« menu is displayed Select the Digital Media ServerEnglish ­39 ­40 English VTuner internet radioStart playback Other playback functionsEnglish ­41 Possible limitations when using an external data mediumInformation on recording and playing television programmes Grundig has no influence on ­ these restrictionsFor example, external hard disks Connecting external data mediaSettings for USB recording Selecting the menuSelecting external data media Switching on automatic previewTesting the external data medium Safely remove disk­44 English ″Pausing time shift ­ programmesRecording programmes One-touch programme recordingEnglish ­45 Presetting programmes to be recordedUsing the electronic TV guide Recording a programme from the channel list­46 English Editing recording data in the ­ timer menuDeleting recording data in the timer menu By manual data entryDeleting programmes in the recording list PlaybackImage data File formatsVideo data Audio dataEnglish ­49 Connecting external ­ data media»USB1« socket of the television set Devices­ in EN 55022/EN 55024 is not possibleFile browser Settings in the USB setup menuSelecting the display mode Setting the display duration for pictures in a slideshowDivX VOD Basic playback functionsEnglish ­51 Playing selected titles Additional playback ­ functionsSelecting chapters on DivX files Selecting titles on DivX filesRepeat functions Selecting a track or picture in steps SkipSelecting a certain passage for­ playback­ Fast forwardAdditional functions TOP text or Flof text modeEnglish ­55 What is HbbTV?HbbTV Operation Additional functions for video sequencesLanguage settings Opening the Settings menuTimer settings Setting the date and timeParental control settings Convenience functions Changing the PIN code Restoring the television to the default settingsUpdating software OAD Updating software OnlineDigi Link functions on your television Device operation Switching the device to standbyEnglish ­61 High definition ­HD ready Connection options Connecting external devices Hi-fi System HeadphonesEnglish ­65 Playing the audio signal via the ­ HiFi system­66 English Connecting a PCSelecting presets for the PC Settings for PC modeEnglish ­67 What is a Common Interface?Access control for CI module and smart card Inserting the CA module­68 English English ­69 LNB settingsCannot­ be changed Settings for motorised antennas DiSEqC­70 English »Discrete« Moves the antenna User modeExpert mode Received­ with »«, »«, »V« or »Λ« and press »OK« to confirm­72 English English ­73 Searching for digital terrestrial TV channels automaticallySearching for digital terrestrial TV channels manually Automatic service update­74 English English ­75 Tuning analogue television channels­Switching the television to ­analogue reception Setting all analogue television channelsStart a automatic scan with »« green oder »« yellow To select the preferred setting­Changing stored analogue channels­ Selecting a channel listSkipping television channels Exiting the settingsSelection­ is still possible using the number ­buttons Entering channel names 8 digit maximumFor digital channels only Open the menu with »MENU« Displaying signal information­78 English English ­79 Technical dataEnvironmental note Service information for dealersEnglish ­81 TroubleshootingProvided ISP ­82 English
Top Page Image Contents