Symphonic CWR20V4 owner manual VCR/DVD recorder Switching, Editing

Page 9

Before you start

Functional overview (cont’d)

Installing batteries in the remote control Using a remote control

Before you

Install two AA batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1

2

3

Note

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

Do not mix new and old batteries together.

Do not use different kinds of battery together, although they may look similar, different batteries may have different voltages.

Make sure that the plus and minus ends of each battery match the indications in the battery com- partment.

Remove batteries from equipment that is not going to be used for a month or more.

When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area.

Do not recharge, short-circuit, heat, burn or disas- semble batteries.

Keep in mind the following when using the remote control:

Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

Use within the operating range and angle as shown.

Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

Replace the batteries when you notice a fall off in the operating range of the remote control.

Within about 23feet (7m)

60˚

Remote control

start Connections Getting started Recording Playing discs

VCR/DVD recorder Switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which com- ponent you wish to operate with the SELECT button.

Editing

VCR MODE

Press the VCR button on the remote control. (Verify that the VCR SELECT indicator is lit.)

DVD MODE

Press the DVD button on the remote control. (Verify that the DVD SELECT indicator is lit.)

Note

Pressing only the SELECT button on the front panel DOES NOT switch the mode of the remote control.You MUST select the correct mode on the remote control.

Pressing the SETUP or the TIMER PROG. button switches the unit to the DVD mode.

VCR SELECT

SELECT button

 

POWER REC SPEED AUDIO

OPEN/CLOSE

 

.@/:

ABC

DEF

 

 

1

2

3

 

 

GHI

JKL

MNO

CH

 

4

5

6

 

 

PQRS

TUV

WXYZ

VIDEO/TV

 

7

8

9

 

VCR button

 

SPACE

 

SLOW

 

0

 

 

 

DISPLAY

VCR

DVD

PAUSE

DVD button

 

 

 

 

 

 

PLAY

 

 

 

STOP

 

DVD

REC/OTR

SETUP

 

TIMER PROG.

DVD SELECT

REC MONITOR

 

ENTER

 

indicator

MENU/LIST

TOP MENU

 

RETURN

VCR SELECT

CLEAR/C-RESET

ZOOM

SKIP

SKIP

SEARCH

CM SKIP

 

 

indicator

MODE

 

 

 

 

 

 

Changing the SETUP menu VCR functions Others Français

9

Image 9
Contents Menu VCR functions Others Français Supplied AccessoryPrecautions Laser SafetyModel No Serial No Before you Precautions cont’dMaintenance Installation LocationMoisture Condensation Warning About CopyrightTable of contents Recording FeaturesPlay Editing222120191817 Functional overview1211 StartFunctional overview cont’d VCR/DVD recorder Switching Start Connections Getting started Recording Playing discsEditing SETUP/DISC/CD menu Display menu First DVDFirst VCR Disc type and Current status of the unit Display messageRecording speed Title/Track and Chapter markMethod 2 and method 3 are only useful in DVD mode Antenna Cable Signal ConnectAntenna Cable DisconnectTo select channels of the cable box or satellite box Connection to a cable box or satellite boxTo playback a DVD disc or a tape To view one channel while recording anotherConnection to an Audio System Start ConnectionsGetting started Recording Easy DVD recording Remote ControlThis unit can record on the follow- ing type of discs only Turn on the unitDesired channel Discs Easy DVD recording Cont’dGetting channels auto- matically Channel settingSelect Manual Preset using Buttons, then press Enter button Channel setting cont’dManual Preset menu will appear Select Channel using K / L Buttons, then press Enter buttonOption window will appear Selecting the TV stereo or SAPOutputs main-audio Secondary Audio ProgramAuto Clock Setting Clock settingManual Clock Setting Clock setting cont’dClock menu will appear, then the settings will be activated Setting the daylight sav- ing time Select on or OFF using Buttons, then press Enter buttonDaylight Saving Time options will appear Selecting the TV aspect ratio If you have a standard TVIf you have a widescreen TV Information Information on DVD recordingRecording speed Restrictions on recordingInformation on DVD recording cont’d Disc type ModeInformation on copy control Making discs playable in other DVD player FinalizeSETUP/DISC menu will appear Screen Settings for the recording format to a blank discSelect Setup using / B Formatting a discDefault Select Auto Chapter usingPress Setup button to exit Setup menu Formatting a disc cont’dSelect Format using K / L buttons, then press Enter button Select Yes using / B but- tons, then press Enter but- tonReformatting a disc Formatting is completeBasic recording Checking the recording picture quality Basic recording cont’dXP SP LP First DVD Press REC Monitor button again to exitOne-touch timer recording Timer recording Press Enter button when all information required is entered Timer recording cont’dPress Power button to turn off To stop the timer recording in processPriority of overlapped settings Hints for timer recordingSettings for an external source Select the input jack type to connect usingConnection to an external source Select a recording speed using REC Speed button. Refer to Settings for an external source cont’dRecording from an external source Recording speed on page 26 for DVD or page 94 for VCRDubbing Mode DVD to VCR duplication will start VCR to DVD duplication will startFinalizing the discs Setting a disc to protect Disc will be protected→ OFF at , then select Yes Information on DVD play Playback Basic playbackBasic playback cont’d When selecting trackFor MP3 playback Press Play B button to start playingPlaying discs using the disc menu First DVD Press TOP Menu button Playing discs using the title menuTOP Menu button Press TOP Menu button to exit the title menuSpecial playback Resume playFast forward / Fast reverse Skipping TV commercials during play Special playback cont’dPause During playback, press CM Skip buttonSlow forward / Slow reverse play Step by step playbackPress Skip G button repeatedly To play step by step back- wardZoom Marker SetupUsing Display button Using Skip H / G buttonsSearch Title/Chapter searchTrack search Search cont’dTime search Able only in the same track orRepeat/Random/Program play Repeat playRandom play Repeat/Random/Program play cont’d Select Program Play using Buttons, then press Enter buttonProgram play Press Play B button to start program playbackSelecting the format of audio and video Switching audio soundtrackSelecting the format of audio and video cont’d Switching subtitlesSelect a desired option using Buttons, then press Switching camera anglesSelect Icon using / B Reducing block noiseInformation on disc editing Editing discs in Video modeGuide to a title list Playback status of the current discInformation on disc editing cont’d Editing discs in VR modeEditing original titles Editing playlistsDeleting titles Editing DVD-RW discs in Video modePutting names on titles Editing DVD-RW discs in Video mode cont’dThis operation may take a Name you entered will be activated for the titleSelect Chapter Mark using Setting or clearing chapter markersSelect Yes using / B but- tons, then press Enter but Ton Chapter markers will be added at the specified time pointsEditing DVD-RW discs in VR mode Original Original/PlayList menu will appearOriginal list will appear Deleting parts of titles Editing DVD-RW discs in VR mode Original cont’dSelect Delete using K / L buttons, then press Enter button Name you entered will be Window for entering a title name will appearActivated for the title Select Chapter Mark using Buttons, then press Enter button Select a desired title using KEnter button Original menu will appear Option window will appear. AddChapter marker which you Setting pictures for thumbnailsSelected will be deleted While to be completedPicture for thumbnail will be set Setting titles to protect Releasing titles from protecting Titles protecting feature once pro- tectedYou are allowed to release Protect on → OFF is selectedSelect PlayList using / B buttons, then press Enter button Editing DVD-RW discs in VR mode PlaylistPlaylist menu will appear Playlist will appearInstructions continue to the next Editing DVD-RW discs in VR mode Playlist cont’dSelect PlayList using / B Original/PlayList menu will appear ScreenPlaylist will appear Select Edit Title Name using K / L buttons, then Name you entered will beActivated for the title First DVD Select a desired title using K Delete Chapter marker which you Selected will be deleted Select Edit using K / L but- tons, then press Enter butSelect Yes using / B but- tons, then press Enter but- ton Adding titles to a Playlist Playlist as you prefer Select Add New Title usingYou can add or delete a title B buttons, thenPlaylist can be deleted if no longer needed Deleting a PlaylistPlaylist will be erased Ing time on discSelect Title Delete using K Editing DVD-R discsYou cannot select Chapter Mark Editing DVD-R discs cont’d Tour of the Setup menu Changing the Setup menuPress Setup button to display SETUP/DISC menu Settings for LanguageSettings for Language cont’d Setup Display Settings for DisplayOSD Background Transparency Default 35% Settings for Display cont’dOSD Background Color Default 1 Green OSD Language Default English Set the language for OSDSettings for Audio Choose the appropriate Audio settings for your equipmentIt will only affect DVD discs during playback Settings for Audio cont’d Settings for Parental lock level Settings for Parental lock level cont’d Press Stop button when the recording is completed Recording and One-touch timer recordingPlayback First VCR Press REC/OTR button to begin the recordingRecording and One-touch timer recording cont’d One-touch timer recordingIndex search When you playback a tape recorded in Hi-Fi stereo Counter ResetOther operations Press g/h buttons to start time searchSymptom Remedy TroubleshootingPower PictureTroubleshooting cont’d Recording/Timer recording/EditingPlayback Remote control Cause SolutionOthers RF converter output Press VIDEO/TV button on the remote controlSelect channel 3 on your TV For more thanLanguage code 101Language Code Glossary 103 SpecificationsReceivable channels RF ConverterEnregistrement simple de DVD TélécommandeRemarque DVD-R ordinaire Ver 2.0/8xEnregistrement simple de DVD suite ’appareil passera en pause et le son sera assourdi Lecture avec magnétoscope106 Pendant la lecture, appuyer sur la touche Pause FEnregistrement avec minuterie par simple pression EnregistrementFunai Corporation Limited Warranty