!!a | Adjusting the Video Channel | I |
| ||
|
|
To view the output of your ‘VCR on the televrsron screen, you must select an unused channel on your TV and tune it to the output of your VCR (factory preset to UHF channel 37).
0 Turn on the TV, select the AV channel or an unused channel on the TV, and turn on the power on the VCR. (See page 5, item 3.)
@Load a prerecorded tape (not supplied) into the VCR.
@If the erasure protection tab on the tape is removed, the VCR will automatically play back the tape. Otherwise press PLAYlx2.
@Tune the selected channel on the TV until the picture from the VCR is displayed on the TV screen. (This TV channel must be selected each time the VCR is used.)
•If picture interference appears on the TV screen in step @ above, you can change the video channel (RF output channel from the VCR) with the following procedure. (If UHF channel 37 is an active broadcast channel in your area, manually select a different channel (UHF 28 to UHF 69) (see below) and then retune your TV as above.)
(A)Press STANDBY (LOW POWER) on the VCR, or STANDBY on the remote control. The VCR enters POWER STANDBY mode. (See page 5, item 2.)
(B)Keep pressing MENU for more than two seconds to light up the :j ‘j:kl F on the VCR display.
(C)Press CHANNELVIA on the VCR or A/T button of
(D)Repeat steps 0 to @ above using the newly selected video channel.
(B)(Cl
10