qbefore Calling for Service
Check this list before calling for service.
Problem |
| Possible Cause/Solutions |
MISCELLANEOUS PROBLEMS |
| I |
|
| |
|
|
|
• No power. | • | See page 5, item 3. |
Cannot turn on the VCR | • | Make sure the power cord is plugged in. |
•Check the outlet, fuse or circuit breaker
• | Cassette cannot be ejected | • | Press TIMER ON/OFF and disengage the timer. |
|
|
| |
*The VCR display does not operate |
|
| |
|
|
| again. Set the timer again if necessary. |
|
|
|
|
|
|
|
|
• | VCR does not record. | • | Cassette’s erasure protection tab has been removed. Use a different |
|
|
| cassette or place adhesive tape over the tab opening. |
|
| • Check if a cassette is loaded. | |
|
| ||
• Cassette is automatically ejected when | *Cassette’s erasure protection tab has been removed Use a different | ||
| pressing REC, or TIMER ON/OFF. |
| cassette or place adhesive tape over the tab opening. |
|
|
|
|
• | No tape movement | • | Make sure VCR is not in pause/still mode. |
|
| • Make sure tape has not reached the beginning or end. | |
|
|
|
|
•Cassette cannot be loaded.
•Make sure there is no other cassette inside.
•Make sure the cassette is properly positioned and reinsert.
•Picture does not change even though • Make sure the VCR is not in the timer setting or clock setting mode
C H A N N E L A/Y ( C H r/V) a r e • Make sure the VCR is not in the channel setting mode. pressed.
•Desired channel position cannot be *The channel has been set to be skipped. Cancel the skip mode for that
selected. | channel. |
NO COLOUR OR POOR PICTURE
•No colour or poor TV picture on normal
•Make sure all the cables are connected properly.
•The heads may be dirty from condensed moisture or the magnetic coating of the video tape. (If this is the case, the heads need to be cleaned. Ask the retailer or Sharp approved service centre.)
*No picture appears or colour is not correct during playback.
•Check all connecting cables.
REMOTE CONTROL PROBLEM
*The VCR cannot be operated by the remote control.
•The remote control unit is not pointed correctly at the photoreceptor window.
•The batteries are exhausted.
•The batteries have not been inserted in the correct direction (+/- polarity).
This unit is equipped with a microprocessor. Its performance could be adversely affected by external electrical noise or interference. If this should happen, unplug the VCR and plug it in again after a few hours.