Connecting a PC
Input resolution settings
Selecting the input resolution
•Some input signals may have to be registered manually to display properly.
•The pairs of input signals (resolutions) in the list below are not distinguishable when received. In such case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again.
1
2
3
1024 x 768 | 1360 x 768 |
|
|
Press MENU and the MENU screen displays.
Press c/d to select “Setup”.
Press a/b to select “Input Signal” and then press ENTER.
4Press a/b to select the desired input signal on the display.
1024 x 768
1360 x 768
(Example)
NOTE
•You can only select the “Input Signal” on the Setup menu when receiving one of the 2 input signals listed above.
59