Sharp LC-65RX1X Appendix Wall mounting, Remove the tape and the string from the wall, 718 982 558

Appendix

Wall mounting

1Mark the monitor’s outline by placing tape at four points on the wall where the LCD-TV’s four corners’ will lie when it is installed.

•When you mark the monitor’s outline on the wall, make sure that the vertical and horizontal lines are made accurate to the TV’s dimension.

•Use adhesive tape that will not leave permanent marks.

2Make diagonal lines from the four corners and mark their intersecting point.

• Diagonally stretch string and mark the intersecting point in a way that no permanent marks will be left on the wall.

3Mount the bracket on the wall by positioning the bracket’s mark that indicates the display’s centre onto the intersecting point.

•The following measurement fi gures are rough estimates. The fi gures differ according to the location where you attach the TV.

41 Remove the screws from the stand.

2 Attach the bracket to the LCD-TV.

3 When adjusting the bracket’s angle, adjust it before installing the TV on the wall.

• The adjusting angles of AN-65AG1 are 0°, 5°, 10°.

4 Lift the TV, remove it from the stand and attach it to the bracket.

•Attach the TV by aligning the monitor’s four corners with the wall markings.

•When you adjust the TV’s angle, make sure to remove the monitor from the wall.

5Remove the tape and the string from the wall.

NOTE

• The above description is for reference. Please mount the TV in a way which properly suits the location.

1579

175

718

982

558

89

wall markings

tape

dimensional markings

72