Remote | Operations | Function |
Button |
|
|
|
|
|
H q; | VCR/ | Starts playback. |
| CD player/ |
|
| VCD player/ |
|
| LD player/ |
|
| DVD player/ |
|
| MD deck/ |
|
| DAT deck/ |
|
| Tape deck |
|
|
|
|
X qa | VCR/ | Pauses playback or |
| CD player/ | record. (Also starts |
| VCD player/ | recording with |
| LD player/ | components in |
| DVD player/ | recording standby.) |
| MD deck/ |
|
| DAT deck/ |
|
| Tape deck |
|
|
|
|
x wa | VCR/ | Stops playback. |
| CD player/ |
|
| VCD player/ |
|
| LD player/ |
|
| DVD player/ |
|
| MD deck/ |
|
| DAT deck/ |
|
| Tape deck |
|
|
|
|
O qs | VCD player/ | Returns to the |
| LD player/ | previous menu or exits |
| DVD player | the menu. |
|
|
|
TV | Selects the channel | |
|
| entry mode, either one |
|
| or two digit. |
|
|
|
Notes
•Some functions explained in this section may not work depending on the model.
•The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described.
•When you press input buttons (VIDEO1, VIDEO2 or DVD), the input mode of the TV might not switch to the corresponding input mode that you want. In this case, press TV/VIDEO button to switch the input mode of the TV.
•To activate the buttons with orange printing, press ALT first before pressing the buttons.
Selecting the command mode of the remote
Set the remote command mode using the RM SET UP button and the remote command mode buttons.
Selecting the command mode
You can switch the command mode (AV1 and AV2) of the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.
Press AV1 or AV2 while holding down RM SET UP.
The indicator flashes once (twice for AV2), then the command mode switches.
To check the command mode of the remote
Press RM SET UP. You can check the remote by the indicator.
Mode | Indicator flashes |
AV1once
AV2twice
To reset the remote to factory settings
Press ?/1, AV ?/1 and MASTER VOL – at the same time.
The indicator flashes 3 times, then goes off.
Note
If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver. To change the command mode of the receiver, see page 41.