Appendix
Reset |
| Updating your TV via |
|
|
|
If complex adjustments are made so that the settings cannot be restored to normal, you can reset the settings to the factory preset values.
1Go to “HOME” > “TV Menu” > “Setup” > “View setting” > “Reset”.
2If you have already set the password, enter it here.
3Press c/dto select “Yes”, and then press
A.
•“Now, TV will restart automatically, OK?” displays on the screen.
4Press c/dto select “Yes”, and then press
A.
•“Now initialising...” displays on the screen and blinks.
•After the reset has completed, the power shuts off and then comes back on. The screen will have returned to its original settings.
5Press a/bto select the desired language listed on the screen, and then press A.
Press c/dto select “HOME” or “STORE”, and then press A.
6Setting the country.
Press a/bto select your country or area, and then press A.
•This setting screen only appears during the initial auto installation.
7The TV searches for and stores all the receivable TV stations according to their settings and the connected antenna.
•To abort the initial auto installation in progress, press
C.
NOTE
•When the TV is in “STORE” mode, repeat steps 1 to 5 to change to “HOME” mode.
Ensure that your TV software version is always up to date. From time to time SHARP will make updated TV base software and DVB software available.
View setting
Download setup
Go to “HOME” > “TV Menu” > “Setup” > “View setting” > “Individual setting” > “Standby search” > “Download setup”.
Searching for updates
The TV automatically determines whether a new software version is available when the TV is in standby mode.
| Item |
Yes | Automatically searches for new software |
updates available when the TV is in | |
| standby mode. |
|
|
No | Does not search for update information. |
|
|
Now | Lowers image brightness for easier |
viewing. Checks if there is new software | |
| immediately. |
|
|
Downloading the software
You can select the method of update.
1If the software is updated, the confirmation message “New download information has been detected.” appears.
•If the TV receives the update service while in standby mode, a confirmation message displays after turning on the power.
2Follow the screen prompts.
Item
| Starts downloading immediately. It takes | |
| approximately one hour to update. You | |
| cannot carry out other operations while | |
Yes | downloading. | |
• Cancels the download by pressing | ||
| ||
| Aon the remote control unit | |
| when “Discontinue” is displayed on | |
| the screen during the update. | |
|
| |
No | Starts downloading automatically several | |
minutes after entering standby mode. | ||
|
NOTE
•Do not unplug the AC cord while receiving the data, otherwise it will not be captured properly.
•Updating the software may take some time.
62