Preparation
Attaching the stand unit
•Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent it from being damaged.
CAUTION
•Attach the stand in the correct direction.
•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
3 Insert the stand into the openings on the bottom | 5 Attaching the stand cover. |
of the TV (hold the stand so it will not drop from | 1Insert the stand cover. |
the edge of the base area). | 2Insert and tighten a short screw into the hole |
Soft cushion | of the stand cover. |
1Confirm that there are screws with the stand unit.
1For 46 inch models
(four long screws, four middle screws and one short screw)
2For 40 inch models
(three long screws, three middle screws and one short screw)
2Attach the supporting post for the stand unit onto the base using the long screws with a screwdriver as shown.
Supporting 
post 
46 inch models | 40 inch models |
4Insert and tighten middle screws into the holes on the rear of the TV.
NOTE
•To detach the stand unit, perform the steps in reverse order.
•A screwdriver is not supplied with this product.
•The TV can be rotated up to 20 degrees to the right and left.
46 inch models | 40 inch models |
46 inch models | 40 inch models |
5