Sharp LC-37SD1E, LC-42SD1E Setting the TV, Antenna, Ferrite Core, Bundling the cables

Quick guide

Setting the TV

Standard DIN45325 plug (IEC 169-2)

75-ohm coaxial cable

Antenna

Connect the antenna cable from your antenna-/ cable socket or the (room-/roof) antenna for antenna input terminal on the back of your TV set to receive digitally/terrestrially broadcast stations.

An indoor antenna can also be used under good reception conditions. Passive and active room antennas are offered commercially. In an active antenna its power is supplied via the antenna input terminal.

The supply voltage (5V) must be correspondingly set under “Supply Voltage”. (See page 18.)

Place the TV close to the AC outlet, and keep the power plug within reach.

Ferrite Core

Product shape varies in some countries.

AC cord

Ferrite Core

The Ferrite Core should be permanently attached and never removed from the AC cord.

Bundling the cables

Cable tie

Cable clamp

Setting the TV on the wall

•This TV should be mounted on the wall only with the wall mount bracket available from SHARP. (See page 35.) The use of other wall mount brackets may result in an unstable installation and may cause serious injuries.

•When you use the AN-37AG2 (SHARP) wall mount bracket, set the angle of the TV to 0° or 5°. Do not set the angle to more than 10°.

•Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury.

•You can ask a qualified service personnel about using an optional bracket to mount the TV to the wall.

4