Sharp LC-46GD7X, LC-52GD7X Input Skip, Input Signal PC input mode only, Press Menu to exit

Useful adjustment settings

Input Skip

This setting allows you to skip the HDMI or DVI input on the “Input Select” menu.

1 Press MENU and the MENU screen displays.

2 Press c/dto select “Setup”.

3 Press a/bto select “Input Skip”, and then press ENTER.

4	Press a/b to select the Input	(INPUT4,
	INPUT5 or INPUT6) you wish to	skip, and

then press ENTER.

INPUT 4 (HDMI1)

INPUT 5 (HDMI2)

INPUT 6 (DVI)

Yes No

5	Press c/dto select “Yes”, and then press
	ENTER.
6	Press MENU to exit.

Input Signal (PC input mode only)

•Some input signals may have to be registered manually to display properly.

•The pairs of input signals (resolutions) in the list below are not distinguishable when received. In such case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again.

1024g7681360g768

NOTE

•You can only select the “Input Signal” on the Setup menu when receiving one of the 2 input signals listed above.

1 Press MENU and the MENU screen displays.

2 Press c/dto select “Setup”.

3 Press a/bto select “Input Signal” and then press ENTER.

4 Press a/bto select the desired input signal on the display.

1024 x 768

1360 x 768

(Example)

41