Technika LCD40-920 manual Using Other Connectors, Inserting Batteries Remote Control Handset

Page 11

Using Other Connectors

You can connect a range of optional equipment to your LCD TV. Possible connections are shown below. Note that cables shown in the illustration are not supplied.

To connect external speakers, use an audio cable. Do not reverse the AUDIO LEFT and AUDIO RIGHT jacks. Turn on the LCD TV and external speaker set after all connections are made. Refer to your speaker set’s manual for further queries.

For connecting a to a device that has SPDIF support, use an appropriate SPDIF cable to enable sound connection.

External Speakers

A device that

supports

SPDIF signal.

Connecting Other Equipment via

Scart

Most devices support SCART connection. You can connect a; DVD recorder, a VCR or a decoder to your LCD TV by using the SCART sockets. Note that cables shown in the illustration are not supplied.

Power off both the TV and the devices before making any connections.

For more information, refer to your device’s own instruction book.

Scart sockets

DVD Recorder

Video Recorder

Decoder

Inserting Batteries in the

Remote Control Handset

Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part.

Insert two AAA/R3 or equivalent type batteries inside. Place the batteries in the right directions and replace the battery cover.

Note: Remove the battery from remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries.

Remote range is approximately 7m/23ft.

Switching the TV On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC, 50 Hz.

Press STANDBY switch. Then the standby LED lights up.

To switch on the TV from standby mode either:

Press the “” button, P+ / P- or a numeric button on the remote control.

Press the -P/CHor P/CH+ button on the TV. The TV will then switch on.

Note: If you switch on your TV via PROGRAMME UP/DOWN buttons on the remote control or on the TV set, the programme that you were watching last will be reselected.

By either method the TV will switch on.

To Switch the TV Off

Press the “” button on the remote control or press the STANDBY switch, so the TV will switch to standby mode.

To power down the TV completely, unplug the power cord from the mains socket.

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active.

English - 10 -

[GB]_MB35_COST_40882W-1810UK_PANEUIDTV_BRONZE2_10064946

_

50164710..indd 10

17.02.2010 14:17:12

 

 

 

 

Image 11
Contents LCD40-920 Contents Preparation AccessoriesFeatures IntroductionSafety Precautions LCD Screen Headphone VolumeInstallation Overview of the Remote Control LCD TV and Operating Buttons Viewing the Connections- Back ConnectorsEnglish Aerial Connection Viewing the Connections Side ConnectorsUsing Side AV Connectors Power ConnectionConnecting the LCD TV to a PC Connecting to a DVD PlayerSwitching the TV On/Off Using Other ConnectorsInserting Batteries Remote Control Handset Connecting Other Equipment via ScartBasic Operations Initial SettingsInput Selection Information Banner General OperationElectronic Programme Guide Widescreen Displaying SubtitlesDigital Teletext ** for UK only Analogue TeletextMoving the channels in the channel list Idtv Menu SystemChannel List Navigating the Entire Channel ListAdding Locks to Channels Setting FavouritesTimers Renaming ChannelsConfiguration Conditional AccessTV Setup SetupHard of Hearing * for EU countries only Favourite ModeReceiver Upgrade Over Air Download OAD Dolby D Digital * for EU countries only optionalLanguage Time Settings ** OptionalAudio Description Optional Standby Search * OptionalCurrent Language SettingsPreferred Movie Subtitle optionalManual Channel Scan Clear Service ListFirst Time Installation Analogue TV Menu System Equalizer VolumeSound Mode optional Feature Menu Pip-PapChild Lock Sleep TimerDefault Zoom Menu TimeoutInstall Menu in AV Modes Hdmi PC Full Mode optionalFull Mode optional Install Menu ProgramDelete Program TableName MovePC Mode Menu System Displaying TV Information Subtitle Teletext149 CinemaTips Not Available, O Available Appendix a PC Input Typical Display ModesThis battery contains lead BatteryAppendix C Supported DVI Resolutions Appendix D PIP/PAP Mode CombinationsDigital Dimensions mmSpecifications Mains AC Operation Important Instruction50164710