General Operation, Electronic Programme Guide

If an active antenna is connected to your TV, you can select this option as On. Antenna power should be “Off” when standard antenna is used instead of the active antenna. See Conﬁguration Menu in the following sections for more information.

Press OK button on the remote control to continue and the following message will be displayed on the screen:

•To select the “Yes” or “No” option, highlight the item by using “” or “” buttons and press the OK button.

The IDTV will automatically tune to the UHF or VHF (** for EU countries) transmission channels, searching for digital terrestrial TV broadcasts and displaying the names of channels found. This process will take about a few minutes. To cancel searching, you can press the “M” button at any time during the process.

After Automatic Search is completed, the following message asking for analogue channel search appears on the screen:

To search for analogue channels, select “Yes”. TV switches to the analogue TV mode. The menu below is displayed to search for analogue channels:

English

Select your Country, Language and Text language by using “” or “” and “” or “” buttons. Press OK or RED button to continue. To cancel, press the BLUE button.

For more information on this process, see “Install Menu” section.

Note: For proper functioning of digital teletext in DTV mode, you should set country as UK in analogue AUTO PROGRAM (for UK only).

General Operation

Pressing the “TV/DTV” button at any time while watching television programmes will switch the TV set between the digital terrestrial television broadcasting and its normal analogue broadcasting.

Information Banner

•Whenever you change channel, using the P- / P+ button or the numeric buttons, the TV displays the broadcast picture along with an information banner at the bottom of the screen (available only in DTV mode). This will remain on the screen for a few seconds.

•The information banner can also be displayed at any time while watching TV by pressing the INFO button on the remote control:

Hint: Not all channels broadcast the programme data. If the name and time of the programme are not available, then information banner will be displayed with blanks.

If the selected channel is locked, you must enter the correct four numeric code to view the channel. “Enter PIN” will be displayed on the screen in such a case:

Electronic Programme Guide

(EPG)

•Some, but not all, channels send information about the current and next events.

•Please note that event information is updated automatically. If there is no event information data available in channels, EPG will be displayed with blanks.

-12 -

[GB]_MB35_COST_40882W-1810UK_PANEUIDTV_BRONZE2_10064946	_	50164710..indd 12	17.02.2010 14:17:13