Select your Country, Language and Text language by using “” or “” and “” or “” buttons. Press OK or RED button to continue. To cancel, press BLUE button. The following menu will be displayed during the automatic tuning:
After APS is finalized, the programme table will appear on the screen. In the programme table you will see the programme numbers and names assigned to the programmes.
If you do not accept the locations and/or the programme names, you can change them via the program table.
Manual Channel Scan
In manual channel scan, the number of the multiplex is entered manually and only that multiplex is searched for the channels. For every valid channel number, signal level and signal quality are shown on the screen.
In both manual and auto search any existing channel in the database is not
Clear Service List (*)
(*)This setting is visible only when the Country option is set to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press “” or “” button to select Clear Service List and then press OK. The following OSD message will be displayed on the screen:
Press OK to cancel. Select Yes by pressing “” or “” button and press OK to delete all of the channels.
English
First Time Installation
The user can use this item to load default settings, which were loaded to the receiver at the factory.
To install factory settings, highlight “First Time Installation” menu item and press OK button, then you will be asked whether or not to delete the settings. Selecting “Yes” by pressing OK button while the “Yes” is highlighted will delete the existing channel table.
Then you will be asked to confirm for deleting all channels and settings:
By selecting Yes and pressing the OK button, the existing channel table will be deleted.
After factory settings are loaded, “First Time Installation” menu will be displayed.
The menu which is displayed for language selection appears on the screen at first. By using “” or “” buttons, select the desired language option, and press OK button to activate.
After then, “First time installation” OSD will appear on the screen. By pressing “” or “” buttons, select the Country you want to set and press OK button (* only for EU countries).
-Next, active antenna mode selection OSD will appear on the screen.Use “” or “” to set and press OK to continue.See the section, “Initial Settings” for more information.
After active antenna mode option is selected, a message asking for automatic search appears on the screen:
Press the OK button to start installation. After search is completed for digital channels, a message asking whether to search for analogue channels appears on the screen: This process is same as described in Automatic Search section.
- 20 -
_ | 50164710..indd 20 | 17.02.2010 14:17:18 | |
|
|
|
|