Obtain the Signal, Switching On | TTE Technology LE32HDF3010

Cable Box,

(Wall Outlet)

RF Coaxial Wire

(75 ohm)

Connections and Setup

Obtain the Signal

The first step in connecting your TV is obtaining the signal. The back panel of your TV allows you to receive analog and/or digital channels by using the HDMI or ANT/CABLE/SAT connections. To obtain the best quality, use the HDMI connection.

Connect the outside ariel to the ANT/CABLE/SAT IN	ANT/CABLE	Outdoor or indoor Antenna
connection on the back of the TV to receive off-air channels.	ANT/CABLE
	/SAT IN
Use an HDMI connection to display the best picture and
sound quality for satellite and cable		Or
• If you have a set-top box, you may need to call your		Or
cable company or satellite service provider. They may
recommend special cables to allow you to view digital		Or
channels.		Or

• The aerial socket (75 OHM - VHF / UHF / cable) can be used for connecting an external aerial or other equipment

fitted with a modulator (video recorder, satellite receiver, etc.). We recommend that you do not connect other equipment (video recorder, satellite receiver, etc.) to your TV set to begin with, so as not to complicate the

set-up procedure with the additional steps involved. Connect them when you have finished setting up the channels.

•Visit www.antennaweb.org for help in deciding what type of antenna to use in order to receive the local digital channels available to you. Enter your location, and the program will list local analog and digital stations available using your antenna.

Switching On

Follow the instructions on this page on how to switch on your TV set and use the remote control before going on to following pages describing how to use the channel scan procedure.

1.Insert two AAA batteries in the remote control. Precautions on using batteries:

-- Only use the battery types specified. -- Make sure you use the correct polarity. -- Do not mix new and used batteries.

-- Do not use rechargeable batteries.

-- Do not expose batteries to excessive heat such as sunshine, fire or the like, throw them in a fire, recharge them or try to open them, as this could cause them to leak or explode.

-- Remove the batteries from the remote control if you are not using it for a long period of time.

2.Connect the power cable to a power outlet. (If the power cable is not connected to the television, please first connect the power cable to the television.) Your TV set should only be connected to an AC supply. It must not be connected to a DC supply. If the plug is detached from the cable, do not, under any circumstances, connect it to a power outlet, as there is a risk of electric shock.

3.When powered on, if the TV set is in standby mode, press on the remote control or on the TV set to turn on the TV.

Switching Off

To put the TV set into standby mode, press on the remote control or on the TV, the TV set remains powered up, but with low energy consumption.

To disconnect power from the TV set, unplug the power cord from the power outlet.