TTE Technology LE32HDF3010 manual Important Safety Instructions, Antenna Lead in Wire Ground Clamp

Important Safety Instructions

1.Read and follow all instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

5.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

6.Protect the power cord from being walked on or pinched particularly at plugs, receptacles, and the point where it exits from the component.

7. Do not use this apparatus near water.

8. Only use the attachments/accessories specified by the manufacturer.

9. Clean only with dry cloth.

10.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the component. When the TV is placed on a cart, use caution when moving the cart to avoid injury from tip- over.

11.Warning: To avoid any injury caused by lean of the product, please always ensure the whole product was place within the table surface in horizontal.

12.Unplug this component during lightning storms or when unused for long periods of time.

13.Refer all servicing to qualified service personnel. Service is required when the component is damaged in any way, such as power supply cord or plug damage, liquid spilled on or objects falling onto the component, rain or moisture exposure, abnormal operation, or if the component has been dropped.

14.If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code, Part 1) provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See following example:

ELECTRICTRICSERVICEI EQUIPMENTMENT

ANTENNA LEAD IN WIRE

GROUND CLAMP

ANTENNAA DISCHARGE UNIT (NECU IT(NECSECTIONTION810810-20)-20)

GROUNDINGCONDUCCONDUCTORSORS (NECSECTIONTION 810810-21)-21)

GROUND CLAMPS

POWERSERSERVICEGROUNDINGGROUNDING ELECTRODESYSYSTEM (NEC ART 250,(NECPARTH)250, PARTH)

2