Connections and Setup
Setup Wizard
Perform the following steps before you press 
on the remote control unit.
•Insert the batteries into the remote control unit.
•Connect the antenna cable to the TV.
•Plug in the AC cord to the AC outlet.
The first time you switch the set on, the Setup Wizard opens, which guides you through the setup process.
1.The first step of the setup requires you to select your preferred language for the menu system. Press ▲/▼ to select your language, then press OK to enter the next screen.
2.A menu screen asks you to set the power on mode.
•Choosing “Home Mode” for the TV assigns the optimal picture settings for most home environments.
•Choosing “Retail mode”, which is not ENERGY STAR compliant, sets the unit up with predefined settings for retail displays. In this setting, the power consumption may exceed the requirements of the ENERGY STAR® qualification. Use ▲/▼ to select the desired location setting (“Home Mode” or “Retail mode”); then press OK to continue to the next screen.
Note: if you select “Retail Mode”, a screen menu will display to ask you go back to the previous menu to select
“Home Mode” by pressing ◄ to select Go Back and press OK to confirm , or you can select “Proceed“ to proceed to
the next screen.
3.Use ▲/▼ to select the current local time zone. Press OK to continue to the next screen.
4.Select either “Antenna” or “Cable/Sat” as the channel scan type. Press OK to begin the channel scan process.
Note: Make sure what kind of connection is made with your TV when selecting “Antenna” or “Cable/Sat”.
5.The screen will change to show the progress of the channel scanning process, available channels will be stored in the TV’s memory.
Note: If you do not want to scan for channels at this time, you can press CLEAR or MENU to exit the scanning process, and perform the channel scan later in the “Setting” menu.
If you are using a cable
6.When the scanning is finished, the unit will switch to the first channel found.
Français
11