Univex 5.4 manual Regulatory Factors, Publishing Information

Page 34
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

d.We will:

Check the remote control, including whether it is covered under the warranty.

Replace any remote we find is defective with a new or refurbished remote, if the defective remote is covered under the warranty. We will ship the replacement remote at our expense.

If a defective remote is not covered under the warranty, we will tell you. We may assess you a flat rate charge for a replacement remote, including shipping and insurance.

REGULATORY FACTORS

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:

1.this device may not cause harmful interference, and

2.this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this device may void your authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the use is encouraged to try to correct the interference by one or more of the following measures:

PUBLISHING INFORMATION

Copyright © 2009. EchoStar Technologies L.L.C., Englewood, Colorado 80112. All rights reserved.

The information in this Guide may change without notice. Revisions may be issued to tell you about such changes.

You should address comments or questions about this User Guide to: techpubs@echostar.com or

Technical Publications, EchoStar Technologies Corporation, 90 Inverness Circle East, Englewood, Colorado 80112.

Document Number: 167821 Printed in

DISH Network is a trademark and service mark of DISH Network.

All product names, trade names, or corporate names mentioned in this Guide are acknowledged to be the proprietary property of the registered owners.

24

Image 34
Contents Remote Control User GuidePage Quick Setup Table of ContentsSETUP AND OPERATION OperationMaking the Remote Work With Your Receiver Insert the BatteriesQuick1Setup Program the Remote to Control Your TV Quick Setup/Operation Placing Your Remote in Limited ModeHow to Use the Recover Button If You Lose Your PictureSAT Mode Remote OperationOperation Picture-In-Picture TV ModeUp/Down Arrow Number ButtonsVCR Mode Page USING THE GUIDE REMOTE CONTROL OVERVIEWREMOTE CONTROL MODES TVs, Remote Operation TV Mode, page S-5 HOW THE REMOTE COMMUNICATESPROGRAMMING FOR OTHER EQUIPMENT VCRs and DVD players, Remote Operation VCR Mode, page S-6LIMITED MODE FIXED CHANNEL MODEAdditional Information PROGRAMMING USING EQUIPMENT CODE TABLESInstructions Scanning for Equipment CodesSCANNING FOR EQUIPMENT CODES Additional Information4 Press POWER SWITCHING BETWEEN TV AND AMPLIFIER VOLUME CONTROL Control Amplifier VolumePROGRAMMING THE REMOTE TO CONTROL A SECOND RECEIVER IN AUX MODE READING OUT THE REMOTE CONTROL CODES CHANGING THE REMOTE AND RECEIVER ADDRESS DISCRETE CODES FOR LEARNING REMOTES3 Press POWER not TV POWER 6 Press SELECT to close the System Info screen TV CODES EQUIPMENT CODESTV CODES CONTINUED VCR CODES VCR CODES CONTINUED Programming in AUX mode Press 2 before entering the tuner DVD PLAYER CODESTUNER/AMPLIFIER CODES amplifier codeTV/VCR COMBO CODES TUNER/AMPLIFIER CODES CONTINUEDTV/VCR/TUNER COMBO CODES TV/DVD COMBO CODESTV/VCR/DVD COMBO CODES Table continues on next pageVCR/DVD COMBO CODES TV/VCR/TUNER COMBO CODES CONTINUEDpage S-2 and Programming for TROUBLESHOOTINGRemote to Control Your TV on Other Equipment on pageControl Your TV on page S-2 at SAT mode see Remote ControlSee Program the Remote to Programming for OtherLIMITED WARRANTY 2. See Troubleshooting on page IF YOU NEED HELPACCESSORY WARRANTY DISH NETWORK’S EXCHANGE PROGRAMSREGULATORY FACTORS PUBLISHING INFORMATIONPage Page Page Page To read out your remote codes, see page 9 for instructions at 1-800-333-DISH3474 For all your customer needs call the Customer Service Center167821