Univex 5.4 manual Reading Out The Remote Control Codes, Instructions

READING OUT THE REMOTE CONTROL CODES

These instructions explain how to check the codes you put in the remote control when you set it up. Be sure to write them in the spaces provided on the inside of the back cover.

Instructions Additional Information

1Press and hold the mode button for the equipment you want the remote to control. When all the other mode buttons light up, let go of the mode button— that mode button should now be flashing.

2Press the POUND (#) button twice. The mode button flashes the number for each digit of the equipment code, with a pause between the groups of flashes. A quick flash is for zero.

For AUX mode, the first group of flashes tells you what type of device the AUX mode controls. A quick flash (zero) before the three-digit code is for a TV; one regular flash is for a VCR or DVD player; and two flashes is for a tuner or amplifier.

For a satellite receiver programmed in AUX mode, the group of flashes tells you the address number.

For example, hold the TV mode button for a TV until all of the other mode buttons light. When you let go, the TV mode light flashes.

For example, if the code is 570, the mode button flashes five times, pauses, flashes seven times, pauses, and quick flashes for zero.

For example, if the TV code is 570, the AUX mode button flashes once quickly, pauses, flashes five times, pauses, flashes seven times, pauses, and quick flashes for zero.

For example, if the AUX mode button is set to control a satellite receiver with address 5, the AUX mode button flashes five times.

9