Sansui SLED2237 owner manual Quick guide for menu operation

>>

CH +/-

Press and release CH + / –. The channel automatically stops at the next channel set into memory.

For proper operation, before selecting channels, they should be set into the memory. See “Memorizing channels” on page 18.

DISPLAY

Press DISPLAY to display the current information on the screen.

When the TV receives a digital signal, the digital information will appear.

	62-1	HDTV_Moving_Picture...	Sleep Timer
	CH-1	TV-MA	Off
	Digital Air		English
	No Program Information is available
USB Memory Information
	Play Time : --:--:--
Message : Now Live View
	USB Memory is unplugged
	Full
	1080i
• Channel number				•	Station name
•	Channel label (if preset) •				Broadcast program name
•	V-Chip rating			•	Signal type
•	Sleep timer			•	Audio language
•	Program guide			•	Picture size
•	Resolution			•	Time Shift display

When the TV receives an analog signal, the analog information will appear.

14Sleep Timer

GOff

Analog Cable

Mono

Full

480i

•	Channel number	• Channel label (if preset)
•	V-Chip rating	•	Signal type
•	Sleep timer	•	Picture size
•	Audio information	•	Resolution
	(Stereo, SAP or Mono)

Press DISPLAY again to clear the call display.

NOTE:

• After a few seconds, DISPLAY screen will return to normal TV operation automatically.

SLEEP

To set the TV to turn off after a preset amount of time, press SLEEP on the remote control. The clock will count up 10 minutes for each press of the SLEEP but- ton (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the sleep time is programmed, the display will appear briefly every ten minutes to remind you that the sleep timer is operating. To confirm the sleep timer setting, press SLEEP and the remaining time will be displayed for a few seconds. To cancel the sleep timer, press SLEEP repeatedly until the display turns to Off.

Quick guide for menu operation

Call menu and for example: Select Language. 1 Press INPUT SELECT to select TV mode.

2 Press MENU. The TV menu screen will appear.

Main Menu

Picture

Audio

CH Channel

Lock

Setup

3	:Select		ENTER :Set
	Press	or	to select “Setup”, then press or
	ENTER.
4	Press	or	to select “Language”, then press
	or	to select the desired language.

…on the following pages the menu can be called in the same way as here.

5 Press EXIT to return to the normal screen.

NOTE:

• If no buttons are pressed for more than about 60 seconds, the menu screen will return to normal operation automatically.

EN 16