RCA F20648 manual Connections & Setup, Things to Consider Before You Connect

Connections & Setup

Things to Consider Before You Connect

Protect Against Power Surges

•Connect all components before you plug any of their power cords into the wall outlet.

•Turn off the TV and/or component before you connect or disconnect any cables.

•Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your TV.

Protect Components from Overheating

•Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.

•Don’t stack components.

•When you place components in a stand, make sure you allow adequate ventilation.

•If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around other components.

Position Cables Properly to Avoid Audio Interference

•Insert each cable firmly into the designated jack.

•If you place components above the TV, route all cables down the side of the back of the TV instead of straight down the middle of the back of the TV.

•If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cables away from audio/video cables.

Important Stand and Base Safety Information

Choose the location for your TV carefully. Place the TV on a stand or base that is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safeguards sheet packed with your TV.

Use Indirect Light

Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.

Connection Pictures

Audio/video cables are usually bundled together. For better visibility, the connection pictures in this book show each cable separately (audio left, audio right, and video).

DEMO						PIN
This Demo			Pin activates
	an automatic .
GUIDE		Plus+ demo
	RETAILERS; this
Do	NOT		remove				will
Demo	Pin.		Removal				dem		o.
disable	the automatic
CONSUMERS:							Pin
REMOVE		this			Demo		cable
		the		G-Link				TV.
and insert			using this
here before

Demo Pin

You must remove the Demo Pin from the G-LINK jack on the back of your TV in order for your TV to operate properly and to connect the G-LINK cable.

6 Chapter 1