Using the Remote Control
OPEN•CLOSE In DVD mode, opens or closes the DVD disc tray.
REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE If programmed, provides transport control for some
SEARCH In VCR mode, accesses Index Search feature.
SPEED In VCR mode, selects a recording speed.
VCR Puts the remote in VCR mode and, if auto tuning is enabled, will turn on the TV and tune to the correct video input channel.
ZOOM In DVD mode, zooms in on the picture.
Using the INPUT Button
Use the INPUT button to scroll through the available video input channels and view components you have connected to the TV.
1.Make sure the component you want to view is turned ON.
2.Press INPUT to tune to an available video input source and view the component.
3.To return to the previous channel, continue pressing INPUT.
DVD |
| ON OFF |
VCR | TV | ON•OFF |
|
| button |
DVD and |
|
|
|
VCR buttons | VOL |
| CH |
|
| ||
|
| MUTE GO BACK |
|
| CLEAR |
| MENU |
|
| OK |
|
| PRESETS |
| SKIP |
| VPORT | INFO | |
|
| GUIDE |
|
| 1 | 2 | 3 |
VPORT | 4 | 5 | 6 |
button | 7 | 8 | 9 |
| INPUT | 0 | ANTENNA |
REVERSE | PLAY | FORWARD |
RECORD | STOP | PAUSE |
REVERSE | AGAIN | ZOOM | OPEN CLOSE | |
and PLAY | ||||
SPEED | SEARCH | STOP | ||
buttons | ||||
|
| button | ||
|
|
|
Programming the Remote to Operate Other Components
The universal remote can be programmed to operate most brands of remote controllable components. The remote is already programmed to operate most RCA, GE, and Proscan components.
Notes: The TV button can’t be programmed on this remote.
The remote may not be compatible with all brands and models of components. It also may not operate all functions of the remote that came with your component.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed for your component, turn the component ON. For example, to program the remote for a VCR, turn on the VCR. Point the remote at the VCR, and press the VCR button. Then press ON¥OFF or CH + (channel up) or CH Ð (channel down) to see if the VCR responds to the remote commands. If the component does not respond, the remote needs to be programmed.
YouÕll use these buttons when programming the remote.
Programming the Remote
There are two ways to program the remote control:
¥automatic code search
¥direct entry
10 | Graphics contained within this publication are for representation only. | Chapter 2 |