Panasonic DMR-ES40V Set up to match your TV and remote control, TV operation, Numbered buttons

Getting started

STEP 4 Set up to match your TV and remote control

Numbered buttons

3, 4, 2, 1

ENTER

DVD/VHS POWER	TV
	POWER
INPUT SELECT	TV/VIDEO CH	VOLUME
VHS	OPERATION	DVD
	SELECT
		TRACKING/V-LOCK

AUDIO

CANCEL/RESET	VCR Plus+ CM SKIP
	PLAY
SKIP/INDEX	SLOW/	FF
	REW SEARCH

DIRECT NAVIGATOR			FUNCTIONS
			PLAY
TOP MENU
SUB MENU			RETURN
S
REC	REC MODE DVD ERASE		TIMEADD/DLTSLIP
SCHEDULE	DISPLAY	STATUS	JET REW
DUBBING		CREATE	VCR/TV
		CHAPTER
VHS	DVD

TV, Í

CH, W, X

FUNCTIONS

RETURN

VCR/TV

∫To exit the screen

Press [RETURN] several times.

∫TV operation

To turn the TV on/off, change the TV input mode, select the TV channel and change the TV volume by means of this remote control, set the remote control as follows.

Point the remote control at the TV

While pressing [Í POWER TV], enter the code using the numbered buttons.

e.g., 01: press [0] > [1].

Manufacturer and Code No.

Panasonic		PHILIPS (RC-5)	03
National	01, 02	RCA	05
QUASAR
		SAMSUNG	14, 18, 19
FISHER	10	SANYO	10
GE	05	SHARP	06, 07
GOLDSTAR	15, 16, 17	SONY	08
HITACHI	12	SYLVANIA	03
JVC	11	THOMSON	05
LG	15, 16, 17	TOSHIBA	09

∫When other Panasonic products respond to this remote control

If other Panasonic products are placed close together, change the remote control code on the main unit and on the remote control (the two must match). When changing the remote control code, make sure the two codes are same.

Under normal circumstances use the factory set code “1”.

MAGNAVOX	03	ZENITH	04
MITSUBISHI	13

≥Test by turning on the TV and changing channels. Repeat the procedure until you find the code that allows correct operation.

≥If your TV brand is not listed or if the code listed for your TV does not allow control of your TV, this remote control is not compatible with your TV.

[1]While stopped

Press [FUNCTIONS].

[2]Select “Other Functions” with [3, 4] and press [ENTER].

[3]Select “SETUP” with [3, 4] and press [ENTER].

FUNCTIONS	DVD
	DVD-RAM	Cartridge Protection Off
		Disc Protection Off
Playback	DIRECT NAVIGATOR	PLAYLISTS
		FLEXIBLE RECORDING
		DV AUTO RECORDING
Schedule	SCHEDULE	SETUP
	123 VCR Plus+	DISC MANAGEMENT
ENTER	Other Functions	Return

18

[4]Select “Setup” with [3, 4] and press [2, 1].

[5]Select “Remote Control Code” with [3, 4] and press [ENTER].

[6]Use [3, 4] to select the code (1, 2 or 3) and

press [ENTER].

≥The code on the unit has been set.

[7]While pressing [ENTER], press and hold the numbered button ([1], [2] or [3]) corresponding to the code you selected in step 6 for about 2

seconds.

≥The code on the remote control has been set.

[8]Press [ENTER].

∫When the following indicator appears on the unit’s display

The unit’s remote control code

Change the code on the remote control to match the main unit’s code (l step 7).

∫To return to the previous screen

Press [RETURN].

VQT0R73