SERVICE ADJUSTMENTS
DIGITAL | SERVICE |
WB |
|
*1 R_DRV 128 | Gain |
2 G_DRV 128 | |
3 B_DRV 128 | 0: x 0.5, 128: x 1, 255: x1.5 |
| |
4 R_BKG 128 | Offset |
5 G_BKG 128 | |
6 B_BKG 128 | 128: offset 0 |
Please input WB items (0
7.Using the numbers buttons on the remote, enter the Data Value for the White Balance setting
(value must be between 1 and 255).
8.Press ENT to WRITE (save) the changes.
9.To exit White Balance Adjustment, press JUMP or OPTIONS
2-4. RESETTING THE TV TO FACTORY CONDITION
Use the following instructions to restore the User Adjustments and Channel Memory settings to the preset factory conditions.
1.While holding down the 
on the Remote Commander, press the POWER button on the TV Switch Unit of the set.
The set restarts and displays the Initial Setup screen. This may take several minutes.
2-4-1. RESETTING THE TV TO FACTORY CONDITION USING SERVICE MODE
1.TV must be in Standby Mode. (POWER off).
2.Press the following buttons on the Remote Commander within a second of each other:
DISPLAY
Channel 5 
Volume + 
POWER .
3.If necessary, press JUMP or OPTIONS to go to DIGITAL mode.
4.Press 8 .
“SERVICE” changes to green RST.
5.Press MUTING .
RST executes the command and displays EXE.
6.Press 0 .
7.When the process is complete the green SERVICE text displays and the LED display as shown below:
TIMER Standby POWER
8.Cycle AC Power (Unplug and Plug AC Cord from the AC Outlet).
9.The set restarts and displays the Initial Setup screen. This may take several minutes.
26 |