Sylvania LC200SL8A owner manual TV Screen Display Mode, Sleep Timer, Letterbox, Zoom

Page 18

WATCHING TV

5TV Screen Display Mode

DTV

2 types of display modes can be selected in the digital mode when the broadcasting station is sending 16:9 video signal.

Press [SCREEN MODE] repeatedly to switch the TV aspect ratio.

5Sleep Timer

The sleep timer can be set to automatically turn off the unit after an incremental period of time.

1 Press [SLEEP] to set the sleep timer.

SLEEP OFF

LETTERBOXZOOM

[LETTERBOX]

Display the digital-supported program in full-screen. Black borders will spread in the upper and lower screen.

[ZOOM]

Enlarge and display the center area of the digital- supported program.

The right and left side of image will be cut off.

Note:

You may not switch the display mode depending on the program.

• Sleep timer display appears on the TV screen.

2 Press [SLEEP] repeatedly to change the amount of time until shut off.

SLEEP 120MIN.

You can set your unit to turn off after a set period of time (from 30 to 120 minutes).

Each press of [SLEEP] will increase the time by 30 minutes.

After set up, the sleep timer display can be called up for checking by pressing [SLEEP].

To Cancel the Sleep Timer

Press [SLEEP] repeatedly until “SLEEP OFF“ is displayed on the TV screen.

Note:

The sleep timer setting display will automatically disappear in 10 seconds.

When you disconnect the unit from the AC outlet or when a power failure occurs, the sleep timer setting will be canceled.

18

EN

Image 18
Contents LC200SL8 a Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceTilt Stand Supplied AccessoriesSymbols Used in this Manual LocationFeatures ContentsRemote Control Function Installing the BatteriesControl Panel Rear PanelAttaching a Wall Mount Bracket sold separately Attach this unit to the wallAntenna Cable Connection ConnectionBasic Connection Connection to Cable Box or Satellite BoxExternal Device Connection Component Video Cable ConnectionVideo Cable Connection Video Connection Digital Audio Output ConnectionMake sure if the unit is connected to antenna or cable Initial SettingInitial Setup Scanning and memorizing the channels automatically startMain Menu Auto Channel ScanPress Setup to exit Language SelectionEnglish Español Français Channel Selection What is the minor channel?Watching TV To Use the Number buttonsMain Switching Each ModeSwitching Audio Mode SAPScreen Information Press DisplayTo Cancel the Sleep Timer TV Screen Display ModeSleep Timer LetterboxOptional Setting Channel Add/DeletePicture Adjustment Closed CaptionTo select Caption SERVICE, then Press Enter repeatedly to change the settingTo select DTVCC, then press Dtvcc Style You can set the desired brightness mode Back Light SettingColor Temperature You can adjust color temperature of the TV screenChip Use Cursor K/L to select TV RATING, then pressAssociation of America Change the settingTo Set the Sub Ratings To select Mpaa RATING, then pressChange Password Enter password again in Confirm PASSWORD. spaceTroubleshooting Troubleshooting GuideMaintenance Information Limited Warranty