Sylvania LC200SL8A Supplied Accessories, Symbols Used in this Manual, Tilt Stand, Location

Page 4

INTRODUCTION

LOCATION

For safe operation and satisfactory performance of the unit, keep the following in mind when selecting a place for its installation:

Shield it from direct sunlight and keep it away from sources of intense heat.

Avoid dusty or humid places.

Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventilation holes.

Install the unit in a horizontal position.

Avoid locations subject to strong vibration.

Do not place the unit near strong magnetic fields.

Avoid moving the unit to locations where temperature differences are extreme.

Be sure to unplug the AC power cord from the outlet before carrying the unit.

TO AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIRE

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.

If, by accident, water is spilled on the unit, unplug the power cord immediately and take the unit to our authorized service center for servicing.

Do not place anything directly on top of the unit.

The serial number of this product may be found on the back of the unit. No others have the same serial number as yours. You should record the number and other vital information here and retain this book as a permanent record of your purchase to aid identification in case of theft.

date of purchase

 

dealer phone No.

 

serial No.

 

dealer purchase from

 

model No.

 

dealer address

 

 

 

 

 

 

 

Note about recycling:

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

5Supplied Accessories

owner’s manual

 

 

 

remote control

batteries

(1EMN22073A)

 

 

 

(NF600UD)

(AA x 2)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

5Symbols Used in this Manual

The following is the description for the symbols used in this manual.

Description refers to:

DTV : Digital TV operation

TV : Analog TV operation

If neither symbol appears under the function heading, operation is applicable to both.

5Tilt Stand

You can adjust the stand to change the angle of the TV (-2.5° to 10°).

-2.5°10°

4

EN

Image 4
Contents LC200SL8 a Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceSupplied Accessories Symbols Used in this ManualTilt Stand LocationFeatures ContentsRemote Control Function Installing the BatteriesControl Panel Rear PanelAttaching a Wall Mount Bracket sold separately Attach this unit to the wallConnection Basic ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxComponent Video Cable Connection External Device ConnectionVideo Cable Connection Video Connection Digital Audio Output ConnectionInitial Setting Initial SetupMake sure if the unit is connected to antenna or cable Scanning and memorizing the channels automatically startMain Menu Auto Channel ScanLanguage Selection Press Setup to exitEnglish Español Français What is the minor channel? Watching TVChannel Selection To Use the Number buttonsSwitching Each Mode Switching Audio ModeMain SAPScreen Information Press DisplayTV Screen Display Mode Sleep TimerTo Cancel the Sleep Timer LetterboxOptional Setting Channel Add/DeletePicture Adjustment Closed CaptionPress Enter repeatedly to change the setting To select Caption SERVICE, thenTo select DTVCC, then press Dtvcc Style Back Light Setting Color TemperatureYou can set the desired brightness mode You can adjust color temperature of the TV screenChip Use Cursor K/L to select TV RATING, then pressChange the setting To Set the Sub RatingsAssociation of America To select Mpaa RATING, then pressChange Password Enter password again in Confirm PASSWORD. spaceTroubleshooting Troubleshooting GuideMaintenance Information Limited Warranty