Sylvania LC200SL8A owner manual Basic Connection, Antenna Cable Connection

Page 9

CONNECTION

Cables not included.

Please purchase the necessary cables at your local store.

INTRODUCTION

5Basic Connection

This section describes how to connect the unit to an antenna, cable/satellite box, etc.

Note:

• Be sure your antenna or other device is connected properly before plugging in the power cord.

[Antenna Cable Connection]

When connecting the unit to an antenna or cable TV company (without cable/satellite box)

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

VHF / UHF

antenna

rear of this unit

RF coaxial cable

or

cable TV company

CONNECTION INITIAL SETTING WATCHING TV

*Once connections are completed, turn on the unit and begin initial setup.

Channel scanning is necessary for the unit to memorize all available channels in your area. (Refer to “Initial Setup” on page 12.)

Note:

For your safety and to avoid damage to device, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than set- top versions.

To easily switch your reception source between antenna and cable, install an antenna selector.

If you connect to the cable system directly, contact the CATV installer.

[Connection to Cable Box or Satellite Box]

Connect the RF coaxial cable on your home outlet to the input jack of the cable/satellite box.

Use another RF coaxial cable to connect the antenna input jack of the unit to the output jack of the cable/satellite box.

OPTIONAL SETTING TROUBLESHOOTING

e.g.)

satellite dish

or

cable TV company

rear of this unit

cable/satellite box

ANT. IN RF OUT

RF coaxial cable

RF coaxial cable

INFORMATION

*Required cables and connecting methods differ depending on the cable/satellite box. For more information, please contact your cable/satellite provider.

9

EN

Image 9
Contents LC200SL8 a Important note is located on the rear of the cabinet IntroductionRADIO-TV Interference PrecautionsSymbols Used in this Manual Supplied AccessoriesTilt Stand LocationContents FeaturesInstalling the Batteries Remote Control FunctionRear Panel Control PanelAttach this unit to the wall Attaching a Wall Mount Bracket sold separatelyBasic Connection ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxExternal Device Connection Component Video Cable ConnectionVideo Cable Connection Digital Audio Output Connection Video ConnectionInitial Setup Initial SettingMake sure if the unit is connected to antenna or cable Scanning and memorizing the channels automatically startAuto Channel Scan Main MenuPress Setup to exit Language SelectionEnglish Español Français Watching TV What is the minor channel?Channel Selection To Use the Number buttonsSwitching Audio Mode Switching Each ModeMain SAPPress Display Screen InformationSleep Timer TV Screen Display ModeTo Cancel the Sleep Timer LetterboxChannel Add/Delete Optional SettingClosed Caption Picture AdjustmentTo select Caption SERVICE, then Press Enter repeatedly to change the settingTo select DTVCC, then press Dtvcc Style Color Temperature Back Light SettingYou can set the desired brightness mode You can adjust color temperature of the TV screenUse Cursor K/L to select TV RATING, then press ChipTo Set the Sub Ratings Change the settingAssociation of America To select Mpaa RATING, then pressEnter password again in Confirm PASSWORD. space Change PasswordTroubleshooting Guide TroubleshootingMaintenance Information Limited Warranty