Sylvania SRTD309 owner manual Set Up For Use, Tv Section, Channel Set Up For The First Time

Page 14
TV SECTION
– SET UP –
B LANGUAGE
[ENGLISH] ESP FRA
AUTO PRESET

TV SECTION

SET UP FOR USE

You can program the tuner to scan all the channels you receive in your area.

NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/DVD channel selector to the output channel of the cable box or satellite box (Ex CH3). Then select the channel to be viewed on the Cable Box or Satellite Box.

CHANNEL SET UP FOR THE

FIRST TIME

TV

1Plug in the TV/DVD power cord

Plug the TV/DVD power cord into a standard AC outlet.

NOTE:

DELETING (OR ADDING)

CHANNEL

TV

The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)

If some digits appear in the corner of

1 Select “CHANNEL SET UP”

- TV SETUP -

the screen, press POWER without unplugging the power cord.

2Turn on the TV/DVD

Press POWER to turn on the TV/DVD.

3Select the On Screen

Language

Press K or L to point to “LAN- GUAGE”.

Then, press ENTER to select “ENGLISH” or “ESP”=Spanish or

“FRA” =French. “[ ]” indicate the selected language.

4 Begin auto preset

– SET UP –

Press K or L to point to “AUTO

LANGUAGE

PRESET”. Then, press ENTER.

[ENGLISH] ESP FRA

B AUTO PRESET

The tuner scans and memorizes all

 

active channels in your area.

 

NOTES:

The TV/DVD distinguishes between standard TV channels and cable(CATV) channels.

The TV/DVD may memorize TV channels as CATV channels if reception conditions is poor. If this happens, try AUTO PRESET action again when reception conditions are better. See “CHAN- NEL SET UP AGAIN” on page 15.

5After scanning

The tuner stops on the lowest memorized channel. If you want to recall the selected channels, you can select the desired channel directly with Number or CHANNEL(CH.) K or L.

B CHANNEL SET UP

Press SETUP on the remote control. LANGUAGE [ENGLISH]

Press K or L to point to “CHAN-

NEL SET UP”.

Then, press ENTER.

2 Select “ADD/DELETE CH”

– CHANNEL SET UP –

Press K or L to point to

B ADD / DELETE CH (TV)

“ADD/DELETE CH”.

AUTO PRESET

Then, press ENTER.

 

3Enter the desired channel number

Press K or L until your desired channel number appears. (You can

also use Number or CH. K/L to

08

ADD / DELETE

enter it.) (Example: CH8)

 

4Delete (or add) it from (into) memory

Press ENTER. The channel number changes to light red. The channel is deleted from memory.

Added channel: Light blue.

Deleted channel: Light red.

To delete another channel, repeat steps [3] and [4].

If you press ENTER again, the channel is memo- rized again.

5Exit the channel setup mode

Press SETUP on the remote control to returns to TV mode.

NOTE: To confirm that channel(s) has been deleted or added, press CHANNEL(CH.) K or L.

– 14 –

EN

0C28

Image 14
Contents Please read before using this equipment INSTRUCCIONES EN ESPAÑOL INCLUIDASThis Owner’s Manual is made of recycled paper SRTD309IMPORTANT SAFEGUARDS S2 8 9 8 A FIGURE A EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODEIMPORTANT COPYRIGHT INFORMATION PRECAUTIONSLASER SAFETY RADIO-TV INTERFERENCELOCATION SUPPLIED ACCESSORYSYMBOLS USED IN THIS MANUAL AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIREDVD SECTION TABLE OF CONTENTSTV SECTION DVD Mode FEATURESTV Mode TV/DVD FRONT PANEL Fig REMOTE CONTROLOPERATING CONTROLS AND FUNCTIONS TV/DVD REAR VIEWINSTALLING THE BATTERIES INDOOR ANTENNA PREPARATION FOR USEANTENNA/CABLE CONNECTIONS VHF/UHF COMBINED ANTENNAFront of the TV/DVD CONNECTING TO EXTERNAL INPUT JACKSCONNECTING TO A STEREO SYSTEM To the audio output jacks Audio/VideoINPUT JACKS, MD DECK OR DAT DECK for DVD only CONNECTING TO AN AMPLIFIER EQUIPPED WITH DIGITALCONNECTING TO A RECEIVER WITH DOLBY DIGITAL DECODER for DVD Center speakerDo not leave this TV/DVD in a car MOBILE CONNECTIONDANGER Do not use this TV/DVD while driving TV SECTION SET UP FOR USECHANNEL SET UP FOR THE FIRST TIME DELETING OR ADDING CHANNELTV SETUP B CHANNEL SET UP LANGUAGE ENGLISH CHANNEL SET UP AGAINSELECTING THE LANGUAGE CHANNEL SET UP ADD / DELETE CH TV B AUTO PRESETWATCHING A TV PROGRAM Note for using the Number on the remote controlTV OPERATION DEGAUSSINGSLEEP TIMER To cancel the sleep timerPLAYABLE DISCS ABOUT THE DISCSDVD SECTION DISC TYPESBASIC PLAYBACK GENERAL FEATURESPLAYING A DISC DISC MENUPAUSE Note for using buttons on the main unitRESUME SLOW FORWARD SLOW REVERSETRACK SEARCH MARKER SETUP SCREENSEARCH FUNCTION TITLE / CHAPTER SEARCHRANDOM PLAYBACK SPECIAL PLAYBACK FUNCTIONREPEATPROGRAM REPEAT TITLE / CHAPTERTRACK SELECTION PLAYING A MP3 DISCMP3 PLAYBACK PROGRAMSUBTITLE LANGUAGE CHANGING THE SETTINGSBLACK LEVEL SETTING AUDIO LANGUAGEFor MP3 THE ON-SCREEN INFORMATIONFor audio CDs TO CHANGE THE ON-SCREEN MENUS CHANGING THE DVD SETUP ITEMSLANGUAGE SETTING When playing disc with copyright Protection DISPLAY SETTINGAUDIO SETTINGS IF YOU FORGET THE PASSWORD PARENTAL CONTROLPARENTAL LEVEL CONTROL LEVELSCorrective Action TROUBLESHOOTING GUIDEProblem Audio or subtitle language cannot be DISC HANDLING MAINTENANCECABINET CLEANING SERVICINGELECTRICAL SPECIFICATIONS SPECIFICATIONSGENERAL SPECIFICATIONS OTHER SPECIFICATIONSConsulte la figura 1 de la página INDICECONTROLES DE OPERACIÓN Y FUNCIONES Consulte la figura 2 de la páginaCONEXIONES DE PREPARACIÓN PARA LA UTILIZACIÓNPARA INSERTAR LAS PILAS ANTENA/CABLECONEXIÓN A UN SISTEMA LA ANTENA INTERIORCONEXIÓN A TOMAS DE ENTRADA EXTERNA ESTÉREOConsulte la figura 9 de la página NOTAS CONEXION MOVILCONEXCIONA UN DECODIFICADOR DOLBY DIGITAL Para DVD SELECCIÓN DE IDIOMA BORRADO O AGREGACION DE CANALESDVD-V CD REPRODUCCIÓN DE UN DVD DE VÍDEO O UN CD DE AUDIOREPRODUCCION BASICA MEMO Get it fixed, at your home or ours For the location of a Sears Service Center in your areaSears Roebuck and Co., Dept. 817WA Hoffman Estates, IL Your Home