Sylvania DVR90DG Installing batteries in the remote control, Using a remote control, Display menu

Page 10

Before you start

Functional overview (cont’d)

Installing batteries in the remote control

Install two “AA” size batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1

2

3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together, although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

Using a remote control

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Line of sight: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23 feet (7m)

30°

Remote 30° control

Guide to Displays the On Screen menu

This unit uses the following the On Screen menu for most operations: Setup menu, Title list, Playlist, Original and Display menu. They allow you to change the playing status of disc during play.

The Display menu also gives you information on the status of the disc.

Display menu

Press [DISPLAY] to call up the Display menu. This menu will give you the information on the playing disc. Some operations are available while disc is playing.

 

4

 

1

 

1

1

0:00:00

DVD-R

 

 

 

Video mode

 

 

 

CH

8

 

5

 

2

 

 

 

XP

 

1:01

6

 

 

3

 

1.Indicates a disc type and a format mode.

NOTE: In some descriptions on this manual, only one disc type is indicated as an example.

2.Indicates a channel number.

3.Indicates a recording mode and possible recording time left.

4.Indicates a title number, chapter number and the time lapse of disc play.

5.Each icon means:

: Search

: Audio

: Subtitle

: Angle (except VR mode)

: Repeat

: Marker

: Noise Reduction

: Zoom

: Surround

6.Indicates current disc status.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Recording Playing discs Editing Setup menu Changing OthersBefore you start Connections Getting started EspañolBefore you start PrecautionsLaser Safety Make your contribution to the environmentPrecautions cont’d Before youAvoid the Hazards of Electrical Shock and Fire Installation LocationSupplied Accessory Moisture Condensation WarningChanging the Editing Setup menu Others Español MaintenanceDolby Digital Recording Table of contents Description FeaturesSymbol Menu Others EspañolFront Panel Functional overviewRear Panel You start Connections Getting started Recording Remote ControlFunctional overview cont’d ReturnDisplay menu Installing batteries in the remote controlUsing a remote control Guide to Displays the On Screen menuSetup menus Front Panel Display Guide This unit ConnectionsConnection to a TV Audio OUTConnection to a cable box or satellite box You cannot record one channel while watching another channelDigital Changing the Recording Playing discs Editing Setup menuConnection to an Audio System Others EspañolGetting started Easy DVD recordingEasy DVD recording Cont’d Select Record Recording Desired On DVD Speed Channel DiscInitial setting Channel settingChannel setting cont’d Adding/deleting channelsSelecting the TV stereo or SAP Using K / L, select TV Audio Select. Press EnterUsing K / L, select Stereo or SAP. Press Enter SAP Secondary Audio ProgramAuto Clock Setting Setting the clockEnter Using K / L, enter the date month / day / year Setting the clock cont’dManual Clock Setting Press Enter againSaving Time Setting the DaylightSelecting the TV aspect ratio YouInformation RecordingInformation on DVD recording Recordable discMaking discs playable in other DVD player Finalize Information on DVD recording cont’dRestrictions on recording Information on copy controlFormatting a disc Choosing the recording format of a blank discFormatting a disc cont’d Setting for Auto ChapterReformatting a disc Turn on the unit. Load a record- able disc Basic recordingFollow the steps below to record TV programs Make sure that the TV input is set on the unitTurn on the unit and load a recordable disc One-touch Timer RecordingStop C Using K / L, enter the Start and End. Press B Timer RecordingPress Timer Prog Using K / L, select the channel number to record. Press BClear Hints for Timer Recording Timer Recording cont’dPriority of overlapped settings Connection to an external source Settings for an external sourceChanging the Editing Setup menu VCR camcorder etcSetting a disc to protect Settings for an external source cont’dRecording from an external source Finalizing the discs Finalizing the discs cont’d Press Setup Using K / L, select Recording. Press EnterUsing K / L, select ON. Press Enter Auto finalizeInformation on DVD play Playing discsGuide to displays Playback Basic playbackMenu / List Playing MP3 disc Setup menu ChangingBasic playback cont’d StartedPlaying discs using the Title menu Playing discs using the Disc menuPress Play B to resume play Skipping TV commercials during play Special playbackResume play X40Step by step playback Special playback cont’dRapid Play Slow forward / Slow reverse playZoom Marker SetupStart Connections Getting started Recording Search Using Skip H / GUsing Display Title/Chapter searchTime search Search cont’dTrack search During CD playback you canRepeat play Repeat/Random/Program playbackRandom playback Selecting the format of audio and video Switching subtitlesRepeat/Random/Program playback cont’d Program playSwitching virtual surround system Switching audio soundtrackSelecting the format of audio and video cont’d Reducing block noise Switching camera anglesDisplay Editing Information on disc editingUsing K / L, select Edit. Press Enter Editing discs in Video modeUsing K / L / / B, select the desired title. Press Enter Deleting titlesPutting names on titles Editing discs in Video mode cont’dTOP MENU, Return Marker will be added or deleting Setting or clearing chapter markersAfter this operation is complet Ed, press Return and then Original list will appear Editing discs in VR mode OriginalOriginal menu will appear Refer to Setting a disc to protect Editing discs in VR mode Original cont’dSetting titles to protect Confirm the indication OFF ON. Press EnterConfirm the indication On OFF. Press Enter Using K / L, select Protect. Press EnterReleasing titles from protecting Key icon will disappear from the title in the Original listUsing K /L, select Edit. Press Enter Editing discs in VR mode PlaylistUsing K / L, select Title Delete. Press Enter Using K /L, select Yes. Press EnterEditing discs in VR mode Playlist cont’d Dividing a titleCombining titles Using s / B, select YesUsing K / L, select Title Combining. Press Enter You startAdding titles to a Playlist Deleting a PlaylistDeleting parts of titles Editing discs in VR mode Original / PlaylistUsing K / L, select Delete. Press Enter Press Enter again to start the previewEditing discs in VR mode Original / Playlist cont’d Playlist Delete Option window will appear. PlaylistConfirm window will appear. Playlist Add You cannot delete the firstSetting pictures for thumbnails Picture for thumbnail will be set. PlaylistTour of the Setup menu Changing the Setup menuSetup Items highlight is the default Contents Press Setup Using K / L, select Playback. Press Enter Language settingUsing K / L, select Language. Press Enter Display setting Language setting cont’dInstructions continue on the next Display setting cont’d Audio settingWhen playing disc with copyright protection Audio setting cont’dUsing K / L, select Audio. Press Enter Digital Out When playing a DVD- RW disc recorded in VR modeUsing K / L, select a setting. Press Enter Settings for Parental lock levelDynamic Range Control Default on Using K / L, select Parental Lock. Press EnterSettings for Parental lock level cont’d YesOthers TroubleshootingSymptom RemedyRecording/Timer Recording/Editing Or has priorityOthers Troubleshooting cont’dError message Cause Solution You press OPEN/CLOSE aLanguage code Recording area has enough spaceFrequently Asked Questions GlossaryTuner SpecificationsGeneral Input / OutputEspañol Fácil grabación de DVDSugerencia 1 Reproduzca el contenido grabado Sugerencia 2 Edite el disco grabadoLimits and Exclusions Customer ServiceTel Funai CorporationDisc type Functions AttributesAfter all recordings, finalize your disc
Top Page Image Contents