Sylvania LC370SS8 owner manual Optional Setting, 5Channel List, Channel l List

Page 22

OPTIONAL SETTING

5Channel List

The channel list function lets you remove undesired channels from the channel registration list.

1 Press [SETUP] to display the main menu.

5 Press [SETUP] to exit.

2Use [Cursor K/L] to select “CHANNEL”, then press [ENTER].

3Use [Cursor K/L] to select “Channel List”, then press [ENTER].

Channell

Autoscan

Channel List

Manual Register

Antenna

4Use [Cursor K/L] to select the channel you want to remove, then press [ENTER].

Channell Listi
Highlight channels for			DTV	6
Ch Up/Down key selection.				27
				27
			DTV	8
				9
			DTV	48
				58
			DTV	67
Ch Select		Watch/Skip	BACK
Ch Select	ENTER	Watch/Skip	Back

•The channel display for the removed channel darkens. You will not be able to select the channel again using [CH K/L].

•To reactivate a removed channel, highlight it using [Cursor K/L] and press [ENTER]. The channel display lightens.

•When you remove a major channel, its minor channels are removed as well.

Note:

•The channel with the “DTV” indicated on the display is ATSC. Otherwise the channel is NTSC.

22

EN

Image 22

Contents To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect Antenna LC370SS8Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceQuick start guide Remote control 5Supplied Accessories5Symbols Used in this Manual LocationContents FeaturesDTV/TV/CATV 5Remote Control Function 5Installing the Batteries5Control Panel Antenna Cable Connection Connection5Basic Connection Connection to Cable Box or Satellite BoxHdmi Connection 5External Device ConnectionHDMI-DVI Connection Component Video Cable Connection Video Cable ConnectionAudio Output Connection Digital Video ConnectionAnalog PC Connection Make sure if the unit is connected to antenna or cable Initial Setting5Initial Setup Scanning and memorizing of channels start automatically5Main Menu 5Auto Channel Scan5Language Selection EnterWatching TV 5Volume AdjustmentWhat is the minor channel? 5Channel Selection5Switching Each Mode 5Still ModeYou can freeze the image shown on the TV screen Stereo 5Switching Audio ModeThis section describes how to switch the audio language SAPBroadcasting Information 5Screen InformationPress Info Day of Memories5TV Screen Display Mode Press Sleep to set the sleep timer 5Sleep TimerTo Cancel the Sleep Timer 5Channel List Optional SettingChannel l List Use the Number buttons or CH K/L to select 5Manual Register5Antenna Confirmation Channel you want to add, then press Enter5Picture Adjustment Adjust the sound setting 5Sound AdjustmentYou can adjust treble, bass and surround Treble, BassClosed Caption Use Cursor K/L to select DTV CC, then press Enter 5DTV Closed CaptionDTV CC DetaililFont Style 5CC StyleFont Size Back Color Font ColorFont Opacity Back OpacityChip Chipip Enter passwordChip ip To Set the Sub Ratings Association of AmericaUse Cursor K/L to select TV Rating, then press ChipipUse Cursor K/L to select New Password, then press Enter Chipip Enter password Confirm passwordClock, Phase 5PC SettingsHorizontal Position, Vertical Position 5HDMI Audio You can set the method of sound input for the Hdmi 1-IN jackTroubleshooting 5Troubleshooting GuideDelayed behind the dialogue Check the batteries of the remote controlRefer to IR Signal Check on Entered channel numberGlossary MaintenanceInformation Atsc5Other Specifications 5General Specifications5Electrical Specification 5Cable Channel DesignationsMemo Limited Warranty

Related manuals

Manual 1 pages 35.39 Kb