LC-XT1
This Projector can automatically tune to the display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be tuned by the
happens, the projector cannot reproduce a proper image and the image may be recognized as a flickering picture, a
This projector has a PC ADJUSTMENT function to enable you to precisely adjust several parameters to match with those special signal formats. This projector has 8 independent memory areas to memorize those parameters
manually adjusted. This enables you to recall the setting for a specific computer whenever you use it.
NOTE: This PC ADJUSTMENT function cannot be operated when the input signal is digital from the DVI terminal or “RGB” is selected on the SYSTEM MENU (P28 and 29).
1 Press the MENU button and the
appear. Press the POINT RIGHT/LEFT button to
select PC ADJUST and press the SELECT button. Another dialog box “Where to reserve” Menu will appear.
2 In this dialog box, you can store the parameter into the area from “Mode 1” to “Mode 8.” When memorizing the new computer parameter, select the Mode with the message “Free” by pressing the POINT UP/DOWN button and the SELECT button. To change
the parameters of the Mode previously set, select the Mode with “Stored.”
3 When the Mode is selected, Parameter adjustment dialog box
appears. Move the arrow to the item that you want to
change by pressing the POINT UP/DOWN button, and adjust each item by pressing the SELECT button to match with your computer.
4 Move the arrow to “Stored” and press the SELECT button. The
parameter is memorized in the selected Mode.
5 To activate the Mode manually adjusted in this PC ADJUSTMENT Menu, select the Mode at the SYSTEM
SELECT
Menu. (Refer to page 28.)
.