Eiki LC-XT1 instruction manual HDB 15-PIN Terminal Analog

Page 49

LC-XT1

HDB 15-PIN TERMINAL (ANALOG)

Connect the display output terminal of the computer to this terminal with the VGA Cable (supplied).

When connecting the Macintosh computer, use MAC/VGA Adapter (supplied).

When connecting the Analog signal from DVI terminal of the computer to this terminal, use DVI/VGA Adapter (supplied).

.

Image 49
Contents Model LC-XT1 To the Owner Safety Precautions Compliances Table of Contents Features and Design LC-XT1 This projector uses nominal input voltages LC-XT1 LC-XT1 Pull out the terminal by holding the handle LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 Turning on the Projector LC-XT1 LC-XT1 LC-XT1 RGB LC-XT1 LC-XT1 Appear. Press the Point RIGHT/LEFT button to Clamp LC-XT1 ‘-‘C’’ Press the Point Down button and a red-arrow icon will Video Video System Menu will appear LC-XT1 LC-XT1 Power management To change the code of the projector Replaced LC-XT1 Recommendation Lamp Replace Indicator Display LC-XT1 LC-XT1 LC-XT1 HDB 15-PIN Terminal Analog LC-XT1 LC-XT1