Eiki LC-XT1 instruction manual

Page 9

LC-XT1

Before setting up the projector, install the Projection Lens on the Projector.

1.Before installation, check where the projector is used and prepare suitable lens. For specifications of the Projection Lens, refer to the manual separately attached or contact the sales dealer where you purchased the projector.

2. For installation, refer to the installation manual supplied to the Projector.

.

Image 9
Contents Model LC-XT1 To the Owner Safety Precautions Compliances Table of Contents Features and Design LC-XT1 This projector uses nominal input voltages LC-XT1 LC-XT1 Pull out the terminal by holding the handle LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 Turning on the Projector LC-XT1 LC-XT1 LC-XT1 RGB LC-XT1 LC-XT1 Appear. Press the Point RIGHT/LEFT button to Clamp LC-XT1 ‘-‘C’’ Press the Point Down button and a red-arrow icon will Video Video System Menu will appear LC-XT1 LC-XT1 Power management To change the code of the projector Replaced LC-XT1 Recommendation Lamp Replace Indicator Display LC-XT1 LC-XT1 LC-XT1 HDB 15-PIN Terminal Analog LC-XT1 LC-XT1