Eiki LC-XT1 instruction manual Video

Page 35

LC-XT1

When connecting to those equipment, select the type of Input source in INPUT SOURCE Menu.

1Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select INPUT SOURCE and press the SELECT button. Another dialog box INPUT SOURCE Menu will appear.

2Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to “Y, Pb/Cb, Pr/Cr” and then press the SELECT button.

Video When connect the composite video output from the video equipment to the VIDEO/Y jack, select “Video” in VIDEO SOURCE Menu.

Y/C When connect the separate Y/C video output from the video equipment to the VIDEO/Y and C jacks, select “Y/C” in VIDEO SOURCE Menu.

S-Video

When connect the S-Video output from the video equipment to the S-Video jack, select “S-Video” in VIDEO SOURCE Menu.

.

Page 34 Page 36
Image 35
Page 34 Page 36
Contents Model LC-XT1 To the Owner Safety Precautions Compliances Table of Contents Features and Design LC-XT1 This projector uses nominal input voltages LC-XT1 LC-XT1 Pull out the terminal by holding the handle LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 LC-XT1 Turning on the Projector LC-XT1 LC-XT1 LC-XT1 RGB LC-XT1 LC-XT1 Appear. Press the Point RIGHT/LEFT button to Clamp LC-XT1 ‘-‘C’’ Press the Point Down button and a red-arrow icon will Video Video System Menu will appear LC-XT1 LC-XT1 Power management To change the code of the projector Replaced LC-XT1 Recommendation Lamp Replace Indicator Display LC-XT1 LC-XT1 LC-XT1 HDB 15-PIN Terminal Analog LC-XT1 LC-XT1
Top Page Image Contents