Clock/Timer
E n g l i s h
2Press VCD 1/2/3, TUNER or TAPE to select the desired source.
➜“CD1 [or 2, 3] XX:XX" indicates the CD mode is selected.
➜“TU XX:XX” indicates the Tuner mode is selected.
➜“TA1 [or 2] XX:XX” indicates the Tape mode is selected.
●Before setting timer, make sure the music source has been prepared.
VCD 1/2/3 – Load the disc(s).
TUNER – tune to the desired radio station. TAPE – load the prerecorded tape into tape deck.
3Press à or á on the system repeatedly to set the hour for the timer to start.
4Press í or ë on the system repeatedly to set the minute for the timer to start.
5Press CLOCK•TIMER to store the timer.
➜"TIMER ON" is displayed, followed by the set timer "XX:XX" and the selected source.
➜
remains on the display.
●At the preset time, the selected sound source will play.
To exit without storing the setting
●Press Çon the system.
Notes:
–When the preset time is reached and the selected disc tray is empty, the next available disc will be selected. If all the disc trays are not available,Tuner will be selected automatically.
–During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.
Deactivating the timer
1Press and hold CLOCK•TIMER for more than two seconds.
2Press Ç on the system to cancel the timer.
➜ "CANCEL" is displayed and the 
disappears.
Activating the timer (for the same preset
time and source)
1Press and hold CLOCK•TIMER for more than two seconds.
2Press CLOCK•TIMER again to store.
➜ The last set timer information is displayed for a few seconds and 
is shown.
Sleep timer setting
The sleep timer enables the system to switch to standby mode automatically at a preset time.
1Press SLEEP repeatedly to select a preset time.
➜The selections are as follows (time in minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120 ™ OFF ™ 15 …
➜"SLEEP XX" or "OFF" is displayed. "XX" is the time in minutes.
2When you reach the desired length of time, stop pressing the SLEEP button.
➜
is shown, except for "OFF" mode.
➜The sleep timer is now set. Before the system switches to standby mode, a countdown of 10 seconds is displayed.
"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"
™"SLEEP"
To check the remaining length of time after sleep timer is activated
●Press SLEEP once.
To change the preset sleep timer
●Press SLEEP again while the remaining sleep timer is shown.
➜ The display will show the next sleep timer options.
To deactivate the sleep timer
●Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button.
30