RE-ASSIGNING DEVICE MODE KEYS
The Teleport™ remote control can be set up to control a second device of an
NOTE: DVD/VCR is preset at the factory to control an RCA DVD. Performing the steps below will overwrite those settings.
1.On Teleport™ press DVD/VCR once: it will blink once. Press and hold SETUP until the
DVD/VCR key blinks twice.
2. Enter 992 on the numeric keypad.
3.Press AMP once, then press DVD/VCR once. The DVD/VCR mode key will blink twice.
The DVD/VCR key is now ready to be programmed for your second audio receiver. See “Programming Device Control” on page 9. To
NOTE: Only one mode can be assigned to an unused mode key at a time.
To | Perform Key Sequence | |
DVD/VCR as | VCRSETUP992 | |
DVD/2nd AMP | ||
AMPDVD/VCR | ||
| ||
|
| |
DVD/VCR as | VCRSETUP992 | |
DVD/2nd TV | TVDVD/VCR | |
|
| |
DVD/VCR as | VCRSETUP992 | |
2nd SAT | ||
TVDVD/VCR | ||
| ||
|
| |
DVD/VCR | VCRSETUP992 | |
back to VCR | DVD/VCR DVD/VCR |
19