Wayne-Dalton WDHC-20 user manual Activating Z-WAVESCENES

Deleting a Z-WAVE®SCENE

1.On Teleport™ press HOME once.

2.Press and release DELETE once.

3.Press SCENE once.

4.Press and release a scene number for the scene you wish to remove. For scenes 0 - 9 press and release the number for the scene (e.g. 2 for scene 2,) for scenes 10 thru 19, press SETUP then the second digit of the scene number (e.g. SETUP + 4 = scene 14.) The HOME red LED blinks rapidly.

5.Press the program button on the node.

6.The HOME green LED blinks twice, then the HOME red LED blinks rapidly.

NOTE: If the HOME red LED emits one long, steady blink, the operation was not successful; repeat the sequence.

ACTIVATING Z-WAVE®SCENES

1.On Teleport™ press HOME once.

2.Press and release a scene number for the scene you wish to control. For scenes 0 - 9 press and release the number for the scene (e.g. 2 for scene 2,) for scenes 10 thru 19, press SETUP then the second digit of the scene number (e.g. SETUP + 4 = scene 14.) The HOME red LED blinks rapidly.

3.On Teleport™ press the ON, OFF, DIM, or BRIGHT KEY. The HOME green LED blinks once.

If ON or OFF is pressed, all nodes associated to the scene will turn on or off. If DIM or BRIGHT is pressed, all nodes associated with a scene dim or brighten with each key press.

NOTE: If the HOME red LED emits one long, steady blink, the operation was not fully successful and indicates one or more Z-Wave®nodes failed to respond in the activated scene. The cause will need to be investigated to determine if it is un-responsive for a temporary condition such as the light bulb is burned out or the node has become unplugged or if the failure is is due to a catastrophic condition with the Z-Wave®node or the node is missing entirely.

Activating ALL ON/ALL OFF

1.On Teleport™ press HOME once.

2.Press and release ALL once.

3.Press either ON or OFF. The HOME green LED blinks once.

NOTE: If the HOME red LED emits one long, steady blink, the operation was not successful; repeat the sequence.

23