Wayne-Dalton WDHC-20 user manual Adding a Node to your Z-WaveNetwork

If you do have an existing Z-Wave®network:

1.Using your existing network’s primary controller, transfer the network information to Teleport™. (page 26)

Your Teleport™ is now a secondary controller in your Z-Wave®network.

NOTE: As a secondary controller, some Z-Wave®commands will not be available such as the ability to add nodes to the network or create additional secondary controllers.

2.Add the nodes to be controlled to a Teleport™ scene. (page 22)

3.Test your scene by activating the scene. (page 23)

If your scene is not correct, repeat step 2.

4.Repeat steps 2 and 3 for each additional scene you wish to create.

Adding a Node to your Z-Wave®Network

To add a Z-Wave®node to your Z-Wave®network(or start creating a network,) perform the following steps:

1.On Teleport™ press the HOME key once.

2.Press and release ADD twice. The HOME key red LED blinks rapidly.

3.Press the program button on the Z-Wave®node.

4.The HOME LED blinks green twice to indicate a successful operation..

NOTE: If the HOME red LED emits one long, steady blink, the operation was not successful; repeat the sequence. Be certain Teleport™ is within 3 ft. of the the node.

Deleting a Node from a Z-Wave®Network

To remove a Z-Wave®node from a Z-Wave®network, perform the following steps:

1.On Teleport™ press HOME once.

2.Press and release DEL twice. The HOME red LED blinks rapidly.

3.Press the program button on the node.

4.The HOME LED blinks green twice to indicate a successful operation.

NOTE: If the HOME red LED emits one long, steady blink, the operation was not successful; repeat the sequence.

21