2. INSTALLATION
2.1 Precautions
•Keep your original packaging. It is designed for this display and is the ideal protection during transport.
•Avoid reflections in the flat panel to reduce eye strain.
•Place the display on a strong and stable table or desk.
•Keep the display away from heat sources and provide enough ventilation in case it is built in a rack or console. Do not put in direct sunlight.
•Make sure computer and display are switched off before connecting the signals.
•Touch panel precautions: Operate with a stylus (tip R0.8 or over, maximum hardness 3H), or with a finger without applying excessive load. Sharp edged or hard articles are prohibited. The gathering of dew in the panel may occur with abrupt temperature or humidity changes. A stable environment condition is recommended. Keep the surface clean. No adhesives should be applied. Avoid high voltage and static charge.
2.2Wall mounting
You can mount the panel to the wall instead of to the foot, by means of the supplied mounting plate. If you do not need to mount the panel to the wall, please skip this item.
Step 1: Remove the panel from the foot
1Position one hand under the panel at the front side. Position the other hand at the rear, under the
2Firmly press down the
3Remove the panel from the foot.
Step 2: Fix the mounting plate to the wall
1Screw the mounting plate to the wall with the 4 supplied screws (A).
MFCD 1219 (TS) User's Guide | 8 |