| SCEPTRE X42 HDTV User Manual |
|
|
Problems | Solutions |
PICTURE ONLY | Make sure the audio cable is connected. |
NO AUDIO | Readjust your volume via the remote control. |
| The TV’s tuner signal must not be lower than 65 %. |
| Turn off the TV, unplug it from the socket. Remove the |
| batteries out of the remote for 30 minutes. Press the remote |
REMOTE | buttons and the power button randomly for a good 2 seconds, |
CONTROL | and then reinstall the batteries. Try the remote to see if it |
DOES NOT | works. |
WORK | The TV’s remote sensor is also housed in the same place as |
| the power indicator light. Please make sure there is line of |
| sight from the remote control’s front sensor to the remote |
| sensor of the TV. |
CANNOT | The TV’s tuner signal must not be lower than 65 %. Change |
RECEIVE | the direction of your antenna and rescan your channels. If |
SUFFICIENT | you have cable call up your cable company and ask about |
CHANNELS | signal strength of your local cable. |
THROUGH THE |
|
ATSC/NTSC |
|
TUNER |
|
| Please adjust your picture setup and make sure the saturation |
NO COLOR | and the RGB are not turned all the way down. |
| The TV’s tuner signal must not be lower than 65 %. Check |
| your signal. |
WEAK SIGNAL | The TV’s tuner signal must not be lower than 65 %. Change |
OR NO | the direction of your antenna and rescan your channels. If |
PROGRAM | you have cable call up your cable company and ask about |
SYMBOL ON | signal strength of your local cable. |
SCREEN |
|
TV CHANNELS | Check your auto lock function’s settings inside the OSD. You |
ARE BLOCKED | may have locked up some channels but forgot about them. |
UNIVERSAL | This TV follows SONY’s universal remote code. Please check |
REMOTE CODE | your hand book for SONY’s codes then apply them. |
THE TV TURNS | This TV is a High Definition liquid crystal display panel TV. It |
ON OR OFF | requires a few more seconds than normal TVs to power up |
SLOWLY AND | and show the picture. |
THE SCREEN |
|
SHOWS UP |
|
SLOWLY |
|
NO SOUND ON | Make sure you have a 3.5 mm |
PC | your pc’s sound output to the TV’s VGA STEREO INPUT. |
- 108 -
www.SCEPTRE.com