TechniSat CAM 1 plus instruction manual Vcr

The timer can be programmed as follows:

Date

>Use the arrow keys to mark the Date column

>Use the numeric key pad to enter the date on which you wish to record a pro-

gramme

Start

>Use the right arrow key to mark the Start column.

>Use the numeric key pad to enter the starting time for the timer.

Stop

>Repeat the steps shown under "Start" to enter the time when the timer should stop, i.e. be switched off.

In order to ensure a smooth operation, there should be a gap of at least one minute between the end of one timer period and the start of the next timer period!

Switching Timer on - Repeat

>Use the right arrow key to mark the column Rpt.

>If required, switch the timer on by pressing the OK key (Display 1x)

>By repeatedly pressing the OK key you can set the timer for further days as follows:

Display:

-Timer off

1x Timer on

DDaily repeat

1W Repeat once per week

2W Repeat every two weeks

3W Repeat every 3 weeks

4W Repeat every 4 weeks

1-5Repeat only on workdays

6-7Repeat only on weekends

Status

>Use the arrow keys to mark the Status column

>Use the OK key to enter the desired status in this line.

1.VCR

Your equipment will be switched on and off for the selected programme.

28