OPERATING INSTRUCTIONS
Turning Power On and Off
■To turn the monitor power ON, press the main power switch ( 
) on the monitor
main unit to ON, and then press the SUB POWER button or the 
or button on the remote control.
■To turn the monitor power OFF, press the SUB POWER button or the 
or 
button on the remote control, and then press the main power switch ( 
) on the monitor main unit to OFF.
•During normal use, the main power switch ( 
) is set in the ON position, and the monitor can then be turned ON/OFF using the SUB POWER button or the 
button on the remote control.
Indicating lamp | Power status |
|
|
|
| Operating |
|
|
| |
|
|
|
|
|
| |||||
Off | Off | When the main power switch |
|
| is set to | |||||
| ||||||||||
OFF. |
|
|
|
|
| |||||
|
|
|
|
|
|
| ||||
|
|
|
|
|
| |||||
|
| When the main power switch ( |
|
| ) is ON, | |||||
|
|
|
| |||||||
Lights red | Off | and the |
| button on the |
|
|
| |||
|
|
|
| |||||||
|
|
|
| |||||||
remote control or the SUB POWER button | ||||||||||
(standby) | ||||||||||
| on the underside of the front of the frame | |||||||||
|
| |||||||||
|
| is OFF. |
|
|
|
|
| |||
|
|
|
|
|
| |||||
Lights or blinks |
| When the main power switch ( |
|
| ) is ON, | |||||
|
|
| ||||||||
On | and the |
|
|
| button on the remote control or | |||||
|
| |||||||||
green | the SUB POWER button on the underside | |||||||||
| ||||||||||
|
| of the front of the frame is ON. |
|
|
| |||||
|
|
|
|
|
|
|
|
|
| |
ENGLISH
•When the indicating lamp blinks in green or the message “POWER SAVE” or “OUT OF FREQUENCY” appears on the screen, there is something unusual about the status of reception. See “Symptoms That Seemingly Appear to be Failures.” 23
Main power switch
SUB POWER
Main unit | Remote | |
controller | ||
|
TIPS
•Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation.
•Turn off the main power switch ( 
) before leaving the monitor out of use for an extended period of time.
•If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit.
9