Dukane P42 Reset Settings Initialization, Signal Check, Display menu item Application, 27 ~

Reset (Settings Initialization)

■The on-screen display system shown to the right will be displayed when the SELECT button is used to select DISPLAY

and moreover DISPLAY INIT is selected from the On-screen Display System 12 . If the

key (select YES) of the SELECT button is pressed at this time, the user adjustment values in the table below for the signal currently being received will be deleted and the factory settings will be restored.

• Pressing the key (select NO) cancels deletion and returns the DISPLAY MENU.

DISPLAY menu item	Display	Application
Horizontal position	H.POSITION	RGB1, RGB2
Vertical position	V.POSITION	RGB1, RGB2, VIDEO1, VIDEO2
Dot clock frequency	CLOCK	RGB1, RGB2
Dot clock phase	PHASE	RGB1, RGB2
Vertical size	V. SIZE	VIDEO1, VIDEO2

ENGLISH

Signal Check

■Changes in the signal status are displayed on the screen as they arise.

Status	Display	Action
The input signal was	• The input terminal and the
switched or the
	horizontal and vertical	-
RECALL button was
	frequencies are displayed in
pressed after AUTO
	a guidance image.
FREQ was turned on.
	• The guidance message
	“POWER SAVE” is
	displayed for about 5
A sync signal could not	seconds.	• Check the power switch of
	• In the event of continued	the PC and its status of
be detected.	absence of a sync signal,	connection.
	the power indicating lamp
	flickers and the monitor
	enters power save mode.
The input signal does	• The guidance message	• Check the input signal
not meet display	“OUT OF FREQUENCY” is
		specifications once again.
specifications or erratic.	displayed.
		27 ~ 30

RGB

RGB1 [D-SUB]

H : 46.5kHz, V : 60.0Hz

VIDEO

VIDEO1

Either VIDEO or S VIDEO is displayed on VIDEO input.

POWER SAVE

OUT OF FREQUENCY

21