Dukane P42 Do not coil or wind the power cord, Remove the power cord for complete isolation

ENGLISH

SAFETY GUIDELINES(continued)

CAUTION	You may have serious injury or your property may be damaged
	unless you follow the instruction below.

•Do not coil or wind the power cord.

This may cause excessive heat resulting in a fire.

•Caution for 200 - 240V operation only

This equipment relies on the protective devices in the building installation for short - circuit and over - current protection. Refer to the following table for the suitable number and location of the protective devices which should be provided in the building installation.

INFORMATIVE EXAMPLES OF PROTECTIVE DEVICES IN SINGLE - PHASE

EQUIPMENT OR SUB - ASSEMBLIES

	Protection	Minimum number	Location
		of fuses or circuit
	against
		- breaker poles
Case A: Equipment to be connected to	Earth faults	1	Phase conductor
POWER SYSTEMS with earthed neutral
reliably identified, except for Case C	Overcurrent	1	Either of the two
below.			conductors
Case B: Equipment to be connected to	Earth faults	2	Both conductors
any supply, including IT POWER
SYSTEMS and supplies with reversible
	Overcurrent	1	Either of the two
plugs, except for Case C below.			conductors
Case C: Equipment to be connected to 3	Earth faults	2	Each phase
			conductor
- wire power systems with earthed
			Each phase
neutral reliably identified.	Overcurrent	2
			conductor

Verify that the protective devices in the building installation meets the conditions in the table prior to installing the equipment.

•Remove the power cord for complete isolation!

For complete isolation from the mains, remove the power cord from the monitor or from the wall socket.

IV