Loewe 52 manual Configuring EPG

Electronic Programme Guide

Calling additional information about the programmes

➠Brief information about many programmes is displayed below the programme list of the broadcasts.

You can call detailed information with the TEXT button if this function is offered by the TEXT icon in the lower left.

Programming a recording for a recorder

➠The selection is in the lower programme list, if not, press the blue button.

65Mark the desired programme.

Red button: Starts recording wizard.

Change or confirm timer data if necessary (see page 54, "The direct way to record").

Then a red dot will be displayed in front of this programme as an identification.

Red button: Deletes the already programmed recording of the red marked programme from the timer.

If the timer data have been transferred to an external recorder, then the timer must also be deleted there.

Configuring EPG

Start the EPG menu

➠EPG mode is started,

if not, press the EPG button.

Call the EPG menu.

EPG menu		Data capture	INFO	END
rovider Station selection	OK		Switch on TV when marked	Sortin

Settings in the EPG menu:

Select provider (only for analogue stations), Station selec- tion, Data capture, Switch on TV when marked, Sorting.

Explanations of setting possibilities in the EPG menu:

Select	In analogue TV reception there may be different provid-
provider	ers who transmit the EPG data for certain station pack-
	ages.
	You can have the list of providers created automatically
	with the yellow button in the provider selection. You can
	select the desired provider at the end of the provider
	search. You can create the list of providers manually with
	the blue button.

Station In the station selection you can determine for which selection station in the programme guide information is to be dis-

played. Only stations with  are shown in the EPG. With the coloured buttons you can select or remove stations or only select the stations from the favourites lists.

Because of the large number of receivable DVB-S stations you should restrict the station selection. This reduces the data entry time and increases the clarity in the EPG.

Marking the stations according to reception ranges:

Analogue stations via antenna/cable, for which the current provider supplies data.

Digital terrestrial stations DVB-T.  Digital cable stations DVB-C.  Digital satellite stations DVB-S.

Data capture	on (for DVB + analogue): data capture for DVB and ana-
	logue stations
	on (only for DVB): data capture only for DVB stations.
	off: no data capture.
	After changes in the EPG menu or after switching off at
	the mains switch the EPG data must be collected first.
	To do this, switch on the set and select the station from
	the analogue stations which you want defined as a pro-
	vider and let the TV set run for about 1 hour with the
	selected station. Or:
	Switch the TV set into standby mode. The display on the
	TV set glows orange after 2 minutes and the EPG data
	entry begins.
	The data capture normally takes place at night between
	2 and 5 o’clock if the TV set is in the standby mode.
Switch on TV	When yes is set, the switched off TV switches on auto-
when marked	matically from the standby mode at the beginning of a
	set program. A screen message appears when switching
	on. If this is not confirmed within 5 minutes with the
	OK button, the TV switches back off automatically for
	safety reasons.
Sorting	The programmes can be sorted either according to their
	start times (chronologically) or according to stations (cor-
	responding to station list).

31 -