Loewe 52 For your safety, Proper use and environmental conditions, Transporting, Power supply

Page 9

For your safety

For your own safety and to prevent unnecessary damage to your device, read and comply with the following safety instructions:

Proper use and environmental conditions

This TV set is designed exclusively for reception and reproduction of video and audio signals and is designed for living rooms or office facilities, and should not be operated in rooms with high humidity, such as a bathroom, or sauna, or where there is a high concentration of dust (e.g. workshops). The manufacturer‘s warranty is only valid for use in the specified permissible environment.

If the set is used outdoors ensure that it is protected against moisture (rain, splashing water, or dew). High humidity and dust concentrations cause leak currents in the device, which can cause a shock hazard if the device is touched, or a fire.

If you have brought the set into a

warm environment from the cold, then wait for about 1 hour before switching it on to avoid formation of condensation.

Do not place any objects filled with liquid or burning candles on the device. Protect the set against dripping and splashing water.

Never place the TV set in a position where it is exposed to vibrations. This can lead to material over- load.

Transporting

Only transport the device in vertical position. Grasp the device on the upper and lower edges of the housing. Never set the TV down on the protruding control unit on the bottom of the TV set. This could damage the control unit.

If the set has to be put down during packing/unpacking, place the TV set with the entire front surface lying flat on a soft underlay such as a blanket or the felt from the packing material.

The LCD screen is made of glass or plastic and can break if not handled properly.

If the LCD screen is damaged and liquid crystal escapes, wear rubber gloves when moving the device. In the case of skin contact immediately wash thoroughly with water.

Power supply

The wrong voltage can damage the set. This equipment must only be connected to a mains power supply which has the same voltage and frequency as that specified on the rating plate; use the mains cable provided. The mains plug of the TV set must be easily accessible so that the device can be disconnected from the mains at any time. When you unplug the mains plug, do not pull on the cable rather pull on the plug housing. The cable in the mains plug could be damaged and cause a short circuit the next time it is plugged in.

Lay out the mains cable in such a manner that it cannot be damaged. The mains cable must not be kinked or laid over sharp edges, stepped on or exposed to chemicals; The latter also applies for the entire equip- ment. A mains cable with damaged insulation can cause electrical shock and is a fire hazard.

Air circulation and high temperatures

The vent slots on the rear panel of the set must always be kept free. Please do not place newspapers or cloths on/over the TV.

Ensure that there is at least 10

 

 

cm free space on the sides and

 

10 cm

above the set for air circulation,

 

 

 

if the set is placed in a cabinet

 

 

or on a shelf.

10 cm

10 cm

 

Like any electronic device, your TV set requires air for cooling. Obstruction of the air circula- tion can cause fires.

The set is suitable for different installation solutions. See the

instructions for assembly for the different installation solutions.

Stand the TV set with the table or floor stand only on a level, sturdy, horizontal base. Particularly ensure that the set does not protrude to the front when placed in or on pieces of furniture.

Set up the device where it is not exposed to direct sunlight and where it is not exposed to additional warming through heating elements.

Prevent metal items, needles, paper clips, liquids, wax, or similar items, from getting into the interior of the device through the vent slots in the rear panel. Such objects can cause short circuits in the set, which could possibly cause a fire.

If something should get into the interior of the set then immediately unplug the mains plug of the device and contact customer service for more information.

-

Image 9
Contents Operating instructions Contents Remote control TV functions Control unit front side of the device Factory settings Connections rear side of the device ComposeAV1 DVD player AV2 DVD recorder USB connection Connections rear side of the device Compose 46 / Compose Video in AVS For camcorderWelcome Operating convenience with wizards Wizards in overviewInfo display and TV index Power supply For your safetyAir circulation and high temperatures Proper use and environmental conditionsEnvironmental protection Installing the TV set Initial installationPreparing the remote control unit Connecting the TV setTurning the set on/off First installation wizardExplanations of the setting possibilities Antenna/cable analogue analogue stations viaDVB-S cable Positioning/aligning DVB-T antenna Explanation of the setting possibilitiesExplanations of the DVB-T antenna Call TV menuOperating convenience General information on menu operationInfo display Assist+ menu Index in the TV setRadio menu Overview diagram TV menu Overview diagramSelect station Daily operationWith the favourites lists Select video sourceExplanation of the favourites lists Explanation of the icons following station namesAdjusting the sound Operation without remote control Adjusting the pictureButton functions Other setting options for DVB stations Explanations of the symbols for sound identificationStatus display Additional selection possibilities for DVB stationsExplanations of some search settings Search/update stations Search wizardManaging stations TV stationsStation Search/update station manual search Call TV menuInput of the station colour standard PAL, SECAM, NTSC-V, PAL60, AutomRestore stations Change, delete, move, rename, restore stationsGreen button Starts Restore stations Delete station Red button Starts Delete stationPut together / change favourites lists Picture in Picture PIP Picture in PictureConfigure Picture in Picture PIP mode Electronic Programme Guide EPG Electronic Programme GuideConfiguring EPG Teletext TeletextDigital teletext MHEG-5 Teletext menuRadio Radio modeConditional Access module CA module Software update OK Start Software update 34Select Start updateTV base software or DVB software Loading new softwareOther settings Timer functionsParental lock Time and date On-screen displaysCall On-screen displays Call time and dateConnection wizard Operating additional equipmentPlayback Signal typeDigital Link Plus Immediate56Select DVD, OK switch over Connecting a DVD player to the TV setPlayback from AV device AV input can also be called manually, howeverConnecting Camcorder/camera Connecting a DVD recorder to the TV setCamcorder Playback from AV device Call AV selectionDevices to the Hdmi DVI connections Devices to the PC in connection Devices to the Component in connection Sound components wizard TV speakersIntegrated Dolby Digital Decoder Setup ConnectingSetup example for Loewe Individual Sound Adjusting the speaker system 34Select Configuration/modification OK continue to Subwoofer phase OK continue to Adjust speaker levelOK continue to set Distance to left front speakerConnecting digital audio amplifiers Connecting audio amplifiersConnecting analogue audio amplifiers Mark the HiFi/AV amplifierAssignment of the digital audio input Audio connection in Hdmi DVI devicesRS-232C interface Direct way to record Timer recording with external devices PhotoViewer Marking photos for slide show Open folderStarting a slide show Calling the PhotoViewer menuConnection MusicBoxStarting the MusicBox Select/play musicMusicBox Browse/sort Call / play play list MusicBox Play listsCreate new play list / add title Blue button Call Create play listMusicBox Menu Operating Loewe equipment Functions for the Loewe DVD player Auro 2216 PS, 8116 DT User interface of loaded DVD Menu original / playlistCard Reader operation ViewVision DR+ „Home menu Rotating the TV set Troubleshooting Amplifier With Teletext various character sets areGeneral data Technical dataElectrical data Connections max. equipmentAccessories AccessoriesIndividual 52 Compose Full-HD+100 Setup possibilitiesIndividual 46 Compose Full-HD+100 Individual 40 Compose Full-HD+100Glossary Conditional Access module See CA moduleCinch cable Cable for transmitting audio or video CI slot See Common InterfacePicture in Picture See PIP TV digital TV analogueHD analogue HD digitalIndex Service