Loewe 52 manual Connecting a DVD recorder to the TV set, Connecting Camcorder/camera

Operating additional equipment

Connecting a DVD recorder to the TV set

➠DVD recorder is registered with the connection wizard. Switch off all equipment before connecting.

Connect the Euro-AV output of the DVD recorder to the AV2 socket of the TV set.

Use a fully equipped Euro-AV cable (available from your dealer) for this.

If you want to receive and record analogue stations with the receiver (tuner) built into the recorder, the recorder must be looped into the aerial cable. Connect the DVD recorder as shown in the connection example below.

Connecting Camcorder/camera

➠Camcorder/camera is registered with the connection wizard.

Switch off all equipment before connecting.

Connect the AV output of the camcorder to the audio input sockets L/R (white/red) and the S-VHS connection of the AVS sockets of the TV set.

Use the AV cable enclosed with the camcorder for this.

Some camcorders only supply an FBAS signal instead of an S-VHS signal at the AV output. In this case use the AVS video input (yellow).

Connection example of a DVD recorder

TV set

ANT2

AV2

S-VIDEO OUT

DVD recorder

TV

R

Connection	Audio in
	L/R (AVS)
example of a
camcorder

	S-VHS connection-	TV set
Camcorder	(AVS)

Playback from AV device

Call AV selection.

AV selection

➠If you want to record DVB stations with an external recorder, the internal receiver of the TV set must be used (see “Timer recording with external devices” on page 55).

Playback from AV device

Call AV selection.

AV selection

COMP. IN

HDMI2/DVI

HDMI1/DVI
PC IN
AVS
DVD-REC	OK
DVD	END
VIDEO
OK Switch to ...

56Select DVD-REC, OK switch over.

Start playback on the connected device.

COMP. IN

HDMI2/DVI
HDMI1/DVI
PC IN
CAM	OK
DVD-REC
DVD	END
VIDEO
OK Switch to ...

56Select CAM, OK switch over.

Start playback on the connected device.

43 -