HANNspree 1506-060B000 manual Searching Codes, Setting Volume Lock

Page 38

6.During the setting process, only digit keys ‘0’ through ‘9’ are valid inputs, while other buttons are deemed invalid and do not affect the code setting. For example, inputting “02” then pressing RETURN does affect the “02” already input.

6.1.3Searching Codes

If the desired electronic equipment code for setting can not be found on the list in the appendix, try to use the code-searching function with operating procedures as follows:

1.Press the corresponding electronic equipment button. The indicator light will come on for 2 seconds then it goes off; after 3 seconds, the indicator light will come on again, showing that the setting mode has been entered.

2.Hold the electronic equipment button while pressing POWER, then input mode

codes 9-9-9 in sequence. If the indicator light does not come on again after going off, the code setting is valid; otherwise the indicator light comes on again after going off for 2 seconds, prompting user to re-enter mode codes.

3.If setting is successful, the electronic equipment code-searching state is entered upon releasing the electronic equipment button. The POWER signal of all manufacturers’ codes under the current electronic equipment mode is then transmitted automatically every 5 seconds.

4.During search, the indicator light will flash when the POWER signal of each electronic equipment is transmitted. When one cycle of code-searching is complete, the indicator light will come on for 2 seconds before going off, exiting search mode automatically.

5.Pressing CH+/CH- during search transmits the next/previous electronic equipment POWER signal without waiting for 5 seconds, and resets the timer to trigger another

5seconds interval.

6.Pressing POWER during search exits search mode without saving the new electronic equipment code; pressing OK during search saves the most recently searched electronic equipment code and then exits search mode.

7.Buttons other than POWER, OK, and CH+/CH- are not functional during search.

6.1.4Setting Volume Lock

Operating procedures are as follows:

English

37

Image 38
Contents 1506-060B000 Table of Contents Table of Contents Regulatory Information FCC Compliance Statement1Description of Warning Symbols Safety Notices Installation Safety Notes LocationImportant Safety Instructions English Personal safety Warranty and Service PrefaceCopyright Package Contents Getting StartedFeatures Introducing the TVControl Panel Description Button Function MenuInput and Output Jacks Description Connector Function Remote Control Description Icon Function Input sourceDVD English Inserting the Remote Control Batteries Connecting an Antenna or Cable TV Setting up your TVBasic Connections Power Connection Connecting External Devices Connecting External EarphonesConnecting to AV Devices Connecting a VCR/ STB/ DVD Player Using Component Video Connecting a VCR/ STB/ DVD Player Using Composite VideoConnecting a PC using VGA Connecting a PC using DVIConnecting Hdmi Hdmi Cable Optional DVD PlayerAdjusting the Volume Using the TV Turning the TV On and OffSwitching Source Signals Performing an Automatic Channel SearchEditing Channel Table or Favorite Channel Adjusting On-Screen Display OSD Settings Main MenuOSD Setting Menus Adjusting Picture SettingsAdjusting Audio Settings Adjusting Channel Settings Channel menuAdjusting V-CHIP Settings Adjusting Setup Settings Enter the Setup menuTroubleshooting Situation SolutionSpecifications ATV Ntsc DTV AtscPC Mode Support Timing Video Mode Support TimingSetting Program Codes IntroductionSetting Volume Lock Searching CodesSetting Channel Lock Factory Setting Mode Transmit Cable code Unlocked Buttons Information Power-out Protection CapabilityOther Descriptions Double Clicking Setup Code for VCR’s Component Program CodesMEI Setup Code for DVD’s Setup Code for Cable Setup Code for Satellite Setup Code for Audio Amp / Tuner’s 3010 Setting the TV on the Wall Wall mounting the TVUsing the Cable Organizer