Huawei VP9050 manual Setting SIP Parameters

HUAWEI VP9050 Executive Video Terminal
User Guide		3 Network Settings
	Parameter	Description
	E1.64	This specifies the site number of a terminal. This number can be
		used to call the corresponding terminal if the terminal is registered
		with the GK. The site number can contain only digits.
	H.323 ID	This specifies the name that is used by the GK to identify a terminal
		registered with it.
		The name can consist of digits and letters.
	Password	This specifies the password used by a terminal to register with the
		GK. The GK authenticates the validity of a terminal by checking
		this password.
		NOTE
		For successful GK authentication, the password set on the terminal should be
		the same as the preset password on the GK.
	Use VoIP gateway	If Use VoIP gateway is selected, VoIP gateway address must be
	VoIP gateway	set. Then you can place calls to terminals connected to the VoIP
		gateway.
	address
Step 2 Save the settings.
	----End

3.3.4 Setting SIP Parameters

When the Session Initiation Protocol (SIP) is used for video communications, the SIP parameters of the terminal, such as whether to register with the SIP server, must be set.

To set the terminal's SIP parameters, do the following:

Step 1 Choose Settings > Network > IP > SIP, and then set the parameters listed in Table 3-5.

Table 3-5SIP parameters

Parameter	Description
Register with server	This specifies whether the terminal registers with the SIP server.
	 Enable: After the terminal is registered with the SIP server
	successfully, it can call a remote site using the site number, site
	name, or IP address.
	 Disable:The terminal does not register with the SIP server, and it
	can call another site using only the IP address.
Server address	This specifies the IP address of the SIP server.

Issue 03 (2011-12-10)	Huawei Proprietary and Confidential	17
	Copyright © Huawei Technologies Co., Ltd