A T O N | A275 INSTALLATION MANUAL |
Chapter 2. System Design & Applications
System Design
The A275 is designed to drive multiple pairs of indoor or outdoor speakers from virtually any audio source. A typical installation con- sists of a home theater receiver zone 2 or zone 3 line level output feeding the A275. The A275 amplified outputs can drive speakers, volume controls, or ATON DLA speaker routers depending upon the application. The advantage of using a DLA along with the A275 is the ability to drive multiple pairs of speakers while enjoying the benefits of the DLA Router: automatic impedance protection, dynamic volume level adjustment, discrete IR remote control, and RF remote control. The A275 is designed to drive one or more DLA’s including the DLA2, DLA4, or DLA6. If you need additional DLA configuration and setup assistance, please refer to the DLA installation manual.
Wiring Considerations
Speaker Wires | Audio Cables | Triggers |
RCA Patch Cables | 2 Conductor Wires with 3.5mm mono connector |
SETTING UP THE A275 WITH A DLA SPEAKER SELECTOR
| A275 Speaker Outputs |
WHITE | RED |
GREEN | BLACK |
W G B R
DLA Speaker Inputs
A275
HOME THEATER RECEIVER
Line Level |
|
Analog Audio |
|
| Output | L R |
AMPLIFIER | SPEAKER | |
INPUTS | ||
OUTPUTS | ||
| ||
8Ω | 8Ω | |
4Ω | 4Ω |
DLA4 SPEAKER SELECTOR
(DLA2, DLA4, or DLA6 can be used)
IMPORTANT!
In this application, the DLA's "AMP" switch should be in the down or "4" Ohm position. Set the "SPKR" switch to the "4" or "8" Ohm position depending on the impedance of the speakers being used.
SPK SPK SPK SPK SPK SPK SPK SPK
8Ω 
8Ω
4Ω 4Ω
HOME THEATER RECEIVER
Line Level
Figure
© ATON 2010 • All rights reserved. | Page 3 |
